Question about 2005 Chrysler Pacifica

3 Answers

Diagram of the engine?

Where is the 2005 pacifica throttle body?

Posted by on


3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 245 Answers

If you follow the hose from your air filter to where it meets the engine you will see your throttle cable also connected to this piece on the intake that is your throttle body.

Posted on May 22, 2009

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Need to refilled freon on a chrylser pacifica 2005 where is it and also diagram for a tune-up

Posted on Nov 18, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 2,005 Answers

A throttle body is just a carburetor with fuel injectors fitted into the top... look on top of the intake manifold

Posted on May 22, 2009

1 Suggested Answer

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Installed timimg belt on a 05 Chrysler Pacifica 3.5L V6. Marks are aligned correctly with engine on TDC. But car starts like timing is off. Has no power. No codes present. Running out of ideas. Can so

I have had this problem on one car where the inside of the gear has detached from shaft , another where the distributor had mal alighned its weights

Jan 06, 2015 | 2005 Chrysler Pacifica

2 Answers

05 Pacfica stalls when backing up, or at stop light, or when driving slowly.

The throttle body and idle air valve needs cleaned with carb cleaner that is oxygen sensor safe. Do not use standard carb cleaner. The hose that runs from the air filter box to the throttle body needs removed to access the throttle plate and passageways.

Dec 03, 2014 | 2005 Chrysler Pacifica

1 Answer

How do you bypass the throttle position switch on 2005 chrysler pacifica?

Have to explain that

A vehicle can not be used with no way to
look a throttle plate position

Think your not understanding what you were told

Aug 09, 2014 | 2005 Chrysler Pacifica

1 Answer

Throttle body sticking

I doubt that is the case,but you can buy
CRC Throttle Body Cleaner at Wal Mart or
auto parts store & follow instructions on can

Throttle Body Plate rotates on sealed ball bearings
& does not contact the throttle bore,so sticking is

Turn the key on & have someone push on the
gas pedal while you watch the throttle plate move

Some of them snap closed when you let off the gas
& then return to where they are set for proper idle

Aug 31, 2012 | 2005 Chrysler Pacifica

1 Answer

I need a diagram for a serpentine belt 3.8 engine

Hi kimberly_40

here is the belt layout for your 2005 Chrysler Pacifica

FIG : Accessory drive beltrouting: -3.5L engin b> (1) Alternator (2) Automatic Tensioner (3) P/S Pump (4) Idler Pulley (5) A/C Compressor (6) Crankshaft Pulley

let me know if you need anything else

EX f31817b.gif

Standing Member of G.O.T.

Feb 19, 2011 | 2005 Chrysler Pacifica

1 Answer

Do I have to remove both manifolds to get to the Knock sensor on a Pacifica 2007 4.0L engine. If so, how many seals are there and do I have to be specific on the torque

only upper
sequence is throttle body is towards the 6 and 5
5317 torque to 105 inch lbs.
some upper gaskets are reusable if you don't break or mess them up but for the cost i would change them anyways.DON"T BREAK THE VACUUM NIPPLE!!! it happens with ease.

Jul 13, 2010 | 2005 Chrysler Pacifica

3 Answers

2005 Pacifica Accelerator Sticks

Have the same vehicle, a 2005 Chrysler Pacifica. Also have the same problem w/ the sticking accelerator. I dope it up real good w/ WD-40 and axle grease. It works for a few days, then goes back to sticking. Drove over my $250 chainsaw the other day, wiping out the cutting bar on the saw. When the boys in DC get off Toyota's case I hope they open an investigation on this defect.

Jan 27, 2010 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

1,484 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides