Can't program my garage door opener

chevy tahoe lift gate not opening - YouTube

? 2:12
www.youtube.com/watch?v=xU6ybiY3F4I
Sep 1, 2010 - Uploaded by 76bluemoon Back lift gate/glass would not open or release. ... Wow, are you sure? .... known issue with tahoe, suburbans, hummers and othergmc vehicles. ... 2007-2012 Yukon Denali Rear Door Lock Actuator Replacement ... 2004 GMC Yukon XL rear liftgateremoval - Duration: 50:17. by Velvethamma 5,814 views.

GOTO HOMELINK.COM TO DOWNLOAD INSTRUCTIONS FOR THIS SYSTEM

YOU WILL NEED TO RE PROGRAM THE UNIT WITH YOUR DOOR OPENER.

HOPE THIS HELPS

they should be a button on your garage door box where the motor is you will have to press that button and then within 30 sec press the one in the denali and they should sync together if not it should say how to with diffrent brands in ur owners manual

Press and hold the two outer buttons on the homelink system in the car until the led flashes rapidly or goes out. Then hold the programmed remote up to the homelink system and at the same time press the button on the remote and the button on the homelink until the led light blinks rapidly or goes out. It should take less than 30 seconds. ----- Then go to the motor head and press the colored learn button on the motor head and go back to the home link and press the homelink button 3 times to activate. If your opener has dip switches stop at -----. Thanks BB

Depending on the type of vehicle home remote system you have and the type of garage door opener installed will determine how you program the system in your vehicle.
Below is a web address for the owners manual to your Buick. It will show you step by step how to set your Buick's remote system to open your garage door.
Good luck.
Regards,
http://www.extendedgmwarranty.com/owners-manual/buick/2007-Buick-Rendezvous.pdf

Press the outer 2 buttons untill the bink rate changes then release.

Press the button you want to train at the same time you hold down an unused button on one of your factory GDO remotes, hold untill flash rate changes.

Press learn button on GDO, press the button you just programmed in the Tahoe, should be programmed.

(Info should be in users manual under HomeLink.)

Check this link, about half way down left side (PDF file.)

http://www.onlinefreeebooks.net/automotive-machinery-power-equipment-ebooks/chevrolet/2007-chevrolet-avalanche-tahoe-suburban-and-gmc-yukon-yukon-xl-yukon-denali-yukon-xl-denali-navigation-manual-pdf.html

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

Sorry this is not a solution but a reply. I don't have an owners manual ****! That's why I'm on the internet, thank you