SOURCE: replacing headlight bulbs on a 2006 chrysler sebring
Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.
SOURCE: fog lights not working on 97 chrysler sebring
check switch continuity and relay , might not have a fuse , also the fog lights on any car will shut of when headlights are switched to high beam
SOURCE: 1997 chrysler sebring lxi, Why do headlight fog-up
Dont replace it.. Take a drill and a very small bit and make 3 holes at the very Bottom of the lense.. This will allow moisture to escape. Make sure to burn the head-lites at least 30 mins after ya do this to clear any excess water/moisture out.. Warning! Dont do this if the lense is made of glass.. do it on Plastic only.. Thanx
SOURCE: 2001 Chrysler Sebring--'no start' and no sound when turn over key
There's a fuse under the hood. It's the relay/ABS fuse (20 amps). You have to pull it out to see if it's blown out. If I remeber correctly, it,s the 3rd or 4th fuse down in the 2nd column of fuses. This supplies power to the relays that control the starter, fuel system, AC, and others.
SOURCE: 2002 Chrysler Sebring problem with the passenger side tail light
brake light switch may need to be adjusted or replaced
Cheers Rob.
227 views
Usually answered in minutes!
×