Hi the key fob light is working have changed the battery but will not do anything have chasnged battery now the alarm keeps going off i am still able to drive the car with the indicator lights flashing so we have had to disconnect the alarm and immobliser heellppp please thanks sarah
I know a website
that has every info on all vehicles and vehicle problems (common/basic and technical both), with their solution In detail.. it's www.reliable-store.com
SOURCE: lost key.need to start car
You can get a key from a Honda dealer. Bring the car VIN, and proof of ownership (title, registration) and they should be able to cut a key right away. countrycurt0
SOURCE: 4*4 not eagaging light keep flashing
Wat i did was to install a reset button on the 4wd computer and each time it flash . i put it into neutral and press the button . For example If i mistakinly press the 4wd while in park the indictor will flash.I then have to put it in nuutrat press the button and it will stop flash and either select or come off from flashing.
SOURCE: Toyota Celica '91 ST184R - Key fob remote does not unlock the car
The ST18x didn't come with a factory fitted alarm, so this is going to be more general.
Your alarm will have a manual disarm somewhere. If you have a small cylindrical device with your keyfob, there will be a receptacle somewhere near the drivers seat. You need to open the door and press the two items together. If not, you may have a button hidden somewhere around the place. In this case the procedure is usually to hold the button while you insert the ignition key and turn it to the ON position.
Some alarms have a small round key. If your alarm has one, or if your keys came with one and you didn't know what it was for, you can open the bonnet, pop a little cover on the alarm box (it will be bolted to the firewall, usually on the right hand side as you look at it) and turn it off until you can get it repaired, or get a new one fitted.
If none of this works and your alarm is an alarm only and not an immobiliser, you can simply open the bonnet and cut all the wires going into the alarm. If it is also an immobiliser, don't touch anything unless you're handy with a soldering iron and multimeter and have a few hours spare. (You would need to pull the cover down from under the steering wheel, then start taking electrical tape off the big block connector with thick wires, and then start rebuilding the wiring that's been chopped to make way for the immobiliser system on a colour-matching basis.)
SOURCE: alarm/ indicator lights keep flashing when i turn the car on
Yes.. the circuit is stuck in the safe mode. Usually when you disconnect the battery it goes in the safe mode as if someone is trying steal the car and cut the battery wire to cut the alarm off, so it goes back on as soon as the circuit completes. So just get that cleared up and you will be fine.
469 views
Usually answered in minutes!
have u tried reprogramming the key FOB?
×