2005 Chevrolet Silverado Logo
Posted on May 20, 2009

Spare tire won't release.

Please describe your How do I unlock the secondary lock on my 2005 chev pickup sprare tire hoist.

3 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 1 Answer
  • Posted on Nov 29, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Nov 29, 2009
Answers
1
Questions
0
Helped
4223
Points
17

This is the worst GM engineering i have ever seen !!!! The secondary locking mech. rust itself in the locked position on will NOT allow the tire to lower. After lowering the tire down approx. 2-4" the saftey lock is still engaged. I was able to reach above the tire and remove the bolt holding the hoist in place. {15 mm wrench}. Keep a floor jack under the tire to support it and as not to fall on your head. After removing the bolt the hoist is hooked on the frame member and must be lifted off to remove. Once you get it on the garage floor it is possible to disengage the locking mech. with a few tools and a big hammer. Good luck This should be a Recall

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 1 Answer
  • Posted on Nov 23, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Nov 23, 2009
Answers
1
Questions
1
Helped
4223
Points
5

You don't, it's impossible. Seriously, it's ridiculous, Chevy owes me 4 hours of my life back, and $80 for a tow. What a bunch of idiot designers.

Ad

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 1 Answer
  • Posted on Dec 16, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Dec 16, 2009
Answers
1
Questions
0
Helped
4223
Points
4

It just happened to me.What a f###ed up system! I had to take it to a dealer to get my spare down-and they left the hoist strung through my spare! Now I have to buy a new hoist and install it. No wonder they are bankrupt!

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2005 Honda spare tire hoist cable lowers but tire doesn't. I'm thinking of removing the hoist to fix it or replace it. It appears that a metal plate between the top of the tire and mechanism is...

My experience is that the tire (being rubber) can stick to the underside of the vehicle. Try prying the tire with a piece of wood or broom handle to release it. Be careful as it may fall. Loosen the cable slightly to catch the spare and not fully drop. Good luck.
1helpful
1answer

Cannot remove spare tire from undercarriage

Hello, this vehicle has a locking device to keep the spare tire from falling down. you will have to perform these steps to remove spare tire.

  • Turn the folding wrench clockwise to raise the jack until it lifts the secondary latch device under the wheel plate.
  • Keep raising the jack until the compact spare tire stops moving upward and is held firmly in place. This lets you know that the secondary latch has released.
  • Lower the jack by turning the folding wrench counterclockwise. Keep lowering the jack until the compact spare tire is resting on the folding wrench
  • 0helpful
    1answer

    Spare tire won't lower on 2005 chev silverado

    you can try pulling on tire while turning crank handle. if cable is bound up in wench assembly you may have to hold the spare up and cut the cable then replace the wench
    4helpful
    1answer

    Removing the spare tire from a 2005 Chev Silverado

    These can be very difficult to deal with. What I've found is that the safety catch gets filled with grit and won't release properly. We usually support the tire with blocks so the weight of the tire is not on the cable and then you can, sometimes, reach up and work the safety catch enough to get it to disengage...But I have seen them so stuck that we've had to cut the secondary lock off which means you have to replace it if you want your spare back under the chassis again. I see the most problems with these in gravel and dirt road areas or areas that use lots of salt and sand in the winter.
    3helpful
    1answer

    I can't get the spare tire out of the rack? 2004 yukon

  • Rotate the hoist shaft counterclockwise in order to lower the spare tire to the ground. Continue to rotate the shaft until the spare tire can be pulled out from under the vehicle and removed. If the spare tire does not lower to the ground, the secondary latch is engaged causing the tire not to lower.
  • If the secondary latch is engaged and the cable end is visible, perform the following procedure: 3.1. Tighten the cable by rotating the hoist shaft clockwise until you hear 2 clicks or feel it skip twice. You cannot overtighten the cable. 3.2. Loosen the cable by rotating the hoist shaft counterclockwise 3 or 4 turns. 3.3. If the spare tire can be lowered, repeat steps 1 and 2 to see if the spare tire can be removed. 3.4. If the spare tire cannot be lowered, rotate the hoist shaft counterclockwise until approximately 15 cm (6 in) of cable is exposed. 3.5. Raise and support the vehicle. 3.6. Place a transmission jack, or equivalent, under the spare tire. 3.7. Position the center of the transmission jack under the secondary latch release button at the center of the spare tire. Arrange the arms of the transmission jack so they will support the tire after it has been released. 3.8. Raise the jack until the spare tire stops moving upward and is firmly held in place, releasing the secondary latch. 3.9. Lower the tire. If the spare tire is hanging by the cable, rotate the hoist shaft counterclockwise until the tire is low enough to remove.
  • 0helpful
    3answers
    1helpful
    2answers

    2005 CHEV SILVERADO SPARE TIRE HOIST JAMMED.

    put weight on it or have someone pull down while turning release need tension so cable can come down
    9helpful
    1answer

    The cable for the spare tire on my 2006 1500 works fine (it's all the way down) but the retainer did not lower at all so I cannot pick up the spare tire. Can anyone help? Thanks

    1. Rotate the hoist shaft counterclockwise until approximately 15 cm (6 in) of cable (1) is exposed.
    2. While holding the latch pin (3), fully depress the latch button (2) and release the secondary latch from the hoist assembly. Some side-to-side and/or up-and-down movement may be necessary to disengage the latch mechanism.
    3. Continue rotating the hoist shaft counterclockwise in order to lower the hoist the rest of the way.
    4. If this does not release the secondary latch, the spare tire hoist will need to be replaced. See the following procedure.
    Important: If the spare tire hoist has been fully raised without a spare tire in place, the secondary latch mechanism may have become engaged. If this has occurred the hoist will not lower and the following steps will need to be followed:
    44helpful
    9answers

    Chevy pick-up spare tire hoist won't release

    Sugerinimo's idea is good but I good not get it too work.. Well, this can be easier or a bit harder. Mine was harder. You are stuck on the secondary tire lock. There is a process in your manual that involves lowering the tire as far as it goes with the secondary lock, then placing your tire jack under the center of the tire holder and jack it back up until its tight to the frame - this should release the secondary lock. In my case this did not work. Plan B, is grab a 15 mm socket, small extension and ratchet. Lower the tire as far as it goes. Locate the 15mm bolt that attaches the tire hanger to the frame, undo the bolt, the hanger is then swinging from the back, lift up the tire and bracket and it will fall off. be careful the tire is heavy.
    Next on the top of the tire you will see a rubber cover the secondary lock slides into. Pull down the boot. You will see two holes along the bottom on the opposite side to the crank. Turn the bottom part of the lock. If you look in the holes you can see where the catch is. Take a slot screw driver and hammer, line up the catch and tap it back in.
    The secondary lock is now free.
    Remember when reinstalling the bolt on the frame to use some locktite.
    Not finding what you are looking for?

    4,233 views

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    ZJ Limited
    ZJ Limited

    Level 3 Expert

    17989 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6988 Answers

    john h

    Level 3 Expert

    29494 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...