Question about 2005 Peugeot 405
My central locking locks then unlocks i think the key fob may need resetting. thanks Paula
Had same trouble with my 406, fixing no problem, with new battery in fob, insert into ignition, turn key, BUT DO NOT START ENGINE, hold button for about 10 seconds release button and remove key from ignition, then try and see if doors lock on remote, if not try again, had to do this a couple of times, and it worked, sorry to say that now my key fob button has completely fell apart, through ware and tare
Posted on Feb 10, 2010
Check the obvious first beacuse this doesnt really seem llike a problem with the key , if the key needs resetting you will not be able to start the car with that key. has the battery in the key fob
been low or been replaced recently
, make sure all the doors are properly shut includind the bootlid , as most modern cars cenral locking systems does the lock unlock if a door is only partially shut,
resetting a key is not a diy job . the key needs to go to a locksmith or peugeot dealer .
let us know how you get on
and please rate
Posted on May 19, 2009
A 'lock then unlock' is due to a 'partially open door' stopping the central lock from engaging .. even if all the doors are actually closed, there is an indication on the dash panel which door it's not happy with .. could try slamming it shut (or start looking for a loose wire)
Posted on Nov 05, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
May 03, 2014 | 1999 Peugeot 406
FOB / PLIP PROGRAMMING :
406 deadlocking remote control has specific button controls, and if the vehicle
has two controls, one is set as primary and the other as secondary.
replacing the Plip, a Primary or Secondary Plip are different part numbers and
must be ordered as required. The white label inside the Plip is labelled PRIM
Turn the Ignition switch ON.
Press the large Plip key button (Primary Plip)
Within 10 seconds press the large Plip key button (Secondary Plip)
If there is one remote, press the Primary plip button twice.
Turn ignition OFF.
Test Plip's for correct operation.
NOTE : On some 406 models, Plips cannot be re-synchronised unless the battery has been disconnected for 1 minute
Oct 27, 2012 | Cars & Trucks
Feb 12, 2010 | 1991 Peugeot 405
Dec 03, 2009 | 1987 Peugeot Liberte
Dec 01, 2009 | 1991 Peugeot 405
Nov 12, 2009 | 2005 Peugeot 405
Nov 02, 2009 | 1991 Peugeot 405
Oct 29, 2009 | 1991 Peugeot 405
Jun 28, 2009 | 2005 Peugeot 405
3,465 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: