How do i unlock my car stereo? Serial #09228390 MR337276

There isn't a 'Reset Code'. There is only an Access Code. This code is a secret.

Your dealership will give the code if you show them your registration document. It's their duty to give it to you free of charge.

It maybe on a small white paper sticker in the side of your glovebox or in the manual.

Or you can buy the code, but you need the serial number on the back of the set.

Daewoo Stereo Code - Locating Radio Code - Car Stereo Help

www.carstereoremoval.com > htm > xstereoCodeDaewoo

Car Stereo Removal - Radio Codes and More. https://CarStereoRemoval.com.

DAEWOO CAR STEREO CODES - Online Service

www.ivgsoft.com > radiocode

DAEWOO CAR STEREO CODES. DAEWOO Car Stereo Codes. We provide car stereo audio factory original anti-theft security codes from unit serial numbers for ...

Nissan Daewoo Radio Code Unlock - Radio Codes

onlineradiocode.com > nissan-daewoo-radio-code

Nissan Daewoo Radio Code. You can unlock your Nissan Daewoo radio using the 17 digit DW, DS or HY serial number. You will need to find the serial number, ...

New Arrival V15 GDS VCI Diagnostic Tool for Hyundai and Kia

Go to Radio and Navigation Codes website if you cannot find your anti-theft radio identification card. Click "Continue" to get to the first page.
Enter your Vehicle Identification Number or VIN when prompted. The VIN is 17 digits and is found at the bottom of the windshield on the driver's side.
Click "Continue" and follow the prompt to enter your phone number and ZIP code. You must enter the phone number and ZIP code that are on file with the dealer. If you haven't changed them, the information is the same as when you purchased the vehicle.
Choose "Continue" and move onto the page to enter your radio serial number. On 2001 and later vehicles, you can find your serial number by pressing and holding the numbers "1" and "6" on your stereo while the vehicle is off. Turn the stereo on and watch for two sets of numbers. The screen will switch between one set of numbers and the second. Each number will start with a letter. Don't worry about the letter and write down both sets of numbers. That is your serial number. For models earlier than 2001, you will have to get the serial number off the back of the stereo. If you don't know how to take the stereo out, you will have to take your vehicle to a dealer.
Enter the radio serial number when prompted. Once you've entered the correct information, Honda will provide you with your radio unlock code. Enter it as directed in the first section.

To unlock your VW factory radio from "SAFE" mode, you will need to enter the radio code. Typically, the code is written on a radio card included with the documentation for the vehicle when the car is first sold.

If you don't have the code, or have lost it, you can retrieve it by visiting your VW dealer. You will need the car's VIN number and the serial number of the radio (located on the body of the radio).

The procedure to enter the code is as follows:

Press the "MODE" and "SCAN" buttons simultaneously and hold them until "1000" appears on the radio display. Release the buttons as soon as this number appears.

Refer to your Radio Card and use the station preset buttons ("1", "2", "3" and "4") to input the code. Press the "1" button repeatedly to input the first digit, the "2" button to input the second digit, etc.

Press and hold the "MODE" and "SCAN" buttons simultaneously until "SAFE" appears again. Release, and the radio should be unlocked.

Do not enter the wrong code more than three times, or the radio will lock itself. Note the dealer can also enter the code for you (they may charge a small fee).

you will need the code to unlock the stereo.
You will probably need to have the radio removed from the dash in order to get the serial number off of it.... but maybe not...
I would call the dealership and ask them what you are required to do to get the code and dirrections on how to enter it...
If you try to enter a random code and it is wrong... your stereo system will lock up and you will have to go thru the ststem reset sequence ( Ignition in ACC for 60+ minutes and enter correct code)

Your Code is 0642

Input the code by pressing preset 1 to scroll through the first digit, preset 2 for the second digit, preset 3 for the third digit, and preset 4 for the fourth digit.

When you have the correct code displayed, press the CD button to unlock the radio. If your radio does not have a CD button, some use the AM/FM or TAPE button to unlock as well.

Please be sure to rate me if I have been of assistance!

1. Enter the permanent factory remote keyless entry (RKE) keypad code.

1. Press the 1/2 button within 5 seconds to activate the programming mode associated with the memory position 1 settings. Holding the 1/2 button for more than 2 seconds after activation erases the stored personal code.

1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed and associated with the memory position 1 settings. Entering any new personal code automatically erases the old personal code.

1. Press the 3/4 button within 5 seconds to activate the programming mode associated with the memory position 2 settings. Holding the 3/4 button for more than 2 seconds after activation erases the stored personal code.

1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed and associated with the memory position 2 settings. Entering any new personal code automatically erases the old personal code.

1. Press the 5/6, 7/8, 9/0, 7/8 and 9/0 button within 5 seconds to activate the programming mode or allow the system to timeout.

1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed. Entering any new personal code automatically erases the old personal code.

call dealer with vin number for vehicle and they will provide you with unlock code... good luck

If you have the Delta stereo (with the power/volume knob in the middle), you need to hold the "DX" and "FM1/2" buttons simultaneously. Hold them down for a few seconds, and SAFE will be replaced with numbers. Use the radio preset keys (1-4 I believe) to enter each number. When the code is successfully input, hold down the DX and FM1/2 buttons again, and the stereo will start to work.

If you mess up entering the code, you can try again. If you mess up a second time, you have to leave the stereo off and the key turned on in the ignition for an hour to allow you two more tries.

yes,
turn the switch on all the way without starting the car.
leave it like that for a couple of hours and the it will unlock itself.
that's the " only " way. unless you drive somewhere for a couple of hours