Code po 402 1996 lexus es 300

SOURCE: How many O2 sensors on a 1997 Lexus ES 300?

according to the manual i have... it has three.... one in the exhaust manifold.... and two in the exhaust pipe..... slightly vauge on the exact location of the last two sensors... but looks like it is after the catylitic converter.

Greg Bernett

• 2993 Answers
• Posted on Jul 12, 2009

SOURCE: location of fuel filter on 2000 lexus es 300

The fuel filter on the ES300 is located under the hood, on the driver's side, by the fenderwell.

SOURCE: 99 lexus es 300 chk engine and trac lock lite on

I had check engine light and TRAC OFF. OBD-II MIL code was P1133 which is Air Fuel Ratio Sensor Response Malfunction and scanned by AutoZone. After disconnecting the battery for 10-15 minutes, the lights went off. I cleaned the gas cap and tightened it firmly. For the last 400 miles, the lights have not come back. When scanning using Snap-on one, no code was detected. I think gas cap was the reason for the lights.

SOURCE: how to replace third brake light on 1997 lexus es 300

"To get access to the 3rd brake light:

- Place each hand against both sides of the plastic housing, and firmly grasp and pull the housing towards you. It might not budge at first, but it should move once you get a good grip on it.

- Pull the housing out just enough so that you can see the brake light bulb and stick your hand underneath. Ignore the speaker wires.

- Pull out the old bulb from the socket (it plugs in/out). Wear rubber gloves when handling the new bulb, and put the new one into the socket.

- Reverse the steps here to put the 3rd brake light back into place. Test out your brake light, and you're done" quoted from lexusk8 @ clublexus.com (great forum)

SOURCE: Trunk Release Button on 1999 lexus es 300 doesn't work

key works remote doesnot work