P0320 (Ignition falure sensor), P2138 (Accelerator Postion Sensor), and P2127 (Throttle/Peddle Position Sensor codes show. Would I (a rookie) be able to replace the Ignition Sensor for starters?? Thank you.
SOURCE: position sensor replacement
An 02 neon does not have an APP sensor only a TPS at the throttlebody. Sounds like a bogus code to me.
SOURCE: how do i replace the throttle position sensor on my '95 K1500?
its just bolts and its next to the air intake/ Please rate my response thank you very much
SOURCE: Throttle/Pedal Position Sensor/Switch B Circuit Range Performance
there is no adjustment on these tps's it's a drive by wire system. If you don't know the vehicle, dont post!
there's 2 sensors contained in the pedal sensor, and one on the throttle plate shaft, more often than not, it's the pedal sensor, and if you replaced that, it's the other one or a loose connection. did you reset the computer after replacing the pedal?
SOURCE: 2005 Kia Sedona, Trouble Code P0320. Everything I
This is a common problem usually related to the crankshaft position sensor. Before you replace it, disconnect the electrical connector to the CPS sensor and clean it with electrical contact spray and add a dab of dielectrical grease. If the problem continues, replace the CPS sensor. It is easy to replace and is not very expensive. It just bolts to the engine block with one or two bolts. I believe the CPS sensor on the Sedona is behind the timing cover on the front of the engine.
SOURCE: I have a Nissan Frontier
Throttle/Pedal Position Sensor/Switch "D" Circuit Low
P2122 - APP Sensor 1 Low Input
Probable Causes:
1 - Failed APP Sensor 1
2 - Open or short circuit condition
3 - Poor electrical connection
----------------------------
P2138 - APP Sensor Performance Condition Fault
Probable Causes:
1 - Failed APP Sensor
2 - Open or short circuit condition
3 - Poor electrical connection
I hope this helps you and thank you
1,058 views
Usually answered in minutes!
×