Can I/How do I reset the maintenance required light on a 1994 XJ6VDP? How difficult is this task?
SOURCE: maitneance required light
Hi.. after you do this step come back and rate as fixya. OK..
Turn the ignitio key to run position
Push and hold for 5 seconds the Trip reset botom.
With the botom pushed turn the ignition key to OFF position.
Keeping pushed the botom.
Turn the Ignition switch to RUN position. keep pushed the trip botom for 10 seconds or untill you see the MAINT_Requi. go OFF.
Remember all this steps with the trip botom pushed. OK.
I hope this solve your question. Thank you for use fixya.
SOURCE: engine maintenance required light , stays on
I have a 1995 dodge 2500 with a v10 and it runs rough at idle and the maintenance required light came on. I have tuned it up and replaced o2 sensors also profesionally cleaned the injectors and ran sea foam cleaner thru the intake and all vacum stuff besides egr valve or injectors wut can i do plus do i have to shut off the maintenance required light for the 02 sensors to work right
SOURCE: Lexus RX350 Reset Maintenance required light
PRESS AND HOLD IN THE TRIPOMETER RESET BUTTON. WITH IT IN, TURN THE KEY TO THE ON POSITION WITHOUT STARTING THE ENGINE. THE DISPLAY WILL COUNT DOWN IN HASH MARKS FROM 6 TO 0. AFTER IT REACHES 0 RELEASE THE TRIPOMETER RESET, TURN THE KEY TO THE OFF POSITION. ONCE YOU RESTART THE LIGHT SHOULD BE OFF.
SOURCE: Maintenance Required light on after dead battery
No its easy . here are the steps turn ignition to acc/ first turn hold reset button located next to odometer rest button. Hold this button for 30 seconds. then turn ignition to next turn/click where lights come on on the dash ex brake air bag etc. hold for another 30 seconds. The maintenance light should flash and go out start vehicle and your maintenance is done. Good luck ad thanks for using FIX YA
SOURCE: Reset the maintenance required light on my 2008 toyota corolla
OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..
Sit inside the driver's seat of the Honda Accord and close the driver's side door. Any interior lights on can prevent the maintenance required light from resetting properly on some year models.
Insert the key in the ignition.
Depress the odometer/trip button located beneath the odometer on the instrument panel. Hold the button down.
Turn the ignition key two clicks forward to the accessory power position. This is also known as the key-on/engine-off position.
Continue to hold down the odometer/trip button for up to 15 seconds until the maintenance required light goes out. On some Accord models, the maintenance required light may blink once before going out.
Release the odometer/trip button and then turn the ignition key to the off position.
Start the Honda Accord to ensure the maintenance required light is no longer illuminated on the instrument panel. If it still is, the reset procedure did not take and you'll need to repeat the procedure.
297 views
Usually answered in minutes!
×