1994 Buick Park Avenue Logo
Posted on May 18, 2009

Sputtering, Missing, Or maybe not getting fuel.

My 1994 Buick Park Ave. Ultra has a few problems #1 Replaced belts on supercharger and now heat and air will not come on. #2 I also had the problem were I would shut the engine off but the heat and air fan kept blowing. #3 A few lights on dash stay on no matter what, coolant light when its full, Traction control light, and another one I cant think of right now. #4 Its newest one, its either missing, or its sputtering like its might be running out of gas. I have had people compare to missing real bad, It sputters and jerks a bit. I have put a few filter on it thinking that would fix it and of course no change. Help I miss driving my baby

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 33 Answers
  • Posted on May 18, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

Joined: May 13, 2009
Answers
33
Questions
0
Helped
16275
Points
98

If you have already done a tune-up changed the wires, plugs the only other thing i can think of would be the fuel pump. If you have a check engine light on along with the other lights your local advance auto parts would check this at no charge. That may give you a clear view of what is wrong. Hope this helps.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1994 buick park ave ultra wont charge battery

sounds like a bad connection or corroded wire
0helpful
1answer

1992 Buick Park Ave. Ultra TPS problem

The code indicates the TPS is still bad and the code is usually right, but it could be a wiring issue at the TPS connector or less likely a computer issue.
To test the TPS circuit, you need to check voltage and ground from the ECM - 5v is the normal reading between the ECM reference circuit and the ECM ground circuit at the TPS connector. Checking the TPS signal circuit to the ECM requires monitoring the TPS signal on a scan tool while jumping the 5v reference and the signal circuits. The TPS reading should go from high when the circuit is jumpered to low when the jumper is removed.
0helpful
1answer

2000 Park Ave Ultra. Super charged belt pully broke and belt flew off while driving. Making a little noise but seems to run OK . Is it OK to drive the car to a mechanic? Service tech at local dealer...

The tensioner pulley on my supercharged 2000 ultra came off and thru the belt. I drove quite a number of miles before I fixed it with no problem.
2helpful
3answers

I can't find a diagram of the belt installation for my 97 Buick Park Avenue. Can you help?

I can help, a belt diagram for a 1997 park ave, some of these cars come with a super charger, heres a diagram that list both the regular belt and then the charger belt, use what is needed, hope this helps.cfccfd3.gif
0helpful
1answer

1994 buick park ave supercharged can the sending

Look in the trunk to see if there is a round cover on the floor of the trunk. If there is then you'll have access to the sender. If not, then you'll have to drop the tank to get to it.
0helpful
1answer

When fuel gets below 1/4 tank it will drop to E and then peg Full before returning to normal on 2000 Buick Park Ave Ultra

fuel pump need to clean just put a seafoam cleaner into ur tank it maybe solve the problem
1helpful
1answer

Installing accessory belt on 94 Buick P/Ave ultra.

You must press on tensioner to make room for new belt. The tensioner then re-traps and keep belt tension when new belt in on. So in other words you have to put belt over all othe pulley leaving tensioner for last using a 3/8 ratchet with out a socket (just the square end) in the hole thats in the tensioner pushdown/up to make room for belt to slide on. If the belt seems short make sure that it is routed the correct way. Good Luck get back to me if you need more help and leave me a "rating". Thanks
0helpful
1answer

91 buick park ave.

Well, that can be a ton of things. Usually it means: A. its not getting enough air, or any air. B. Its not getting enough gas. It could be a problem with the Mass flow Sensor- which can be cleaned or replaced-, or maybe a bad fuel pump or bad fuel lines or something. Either way the problem sounds like it just can't run because it can't get enough gas.
Not finding what you are looking for?

436 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...