Location of speed sensor for a 2003 dodge durango

https://www.google.com/search?q=1998+dodge+durango+wiring+diagram

Fuses and relay Dodge Durango - Fuse box diagram

fusesdiagram.com https://fusesdiagram.com > Dodge

For Dodge Durango 1997, 1998, 1999, 2000, 2001, 2002, 2003 model year. Fuse box in engine compartment. fuse box location. fuse box diagram (type 1).

Dodge Durango 1998-2003 Fuse Box Location and Diagram

YouTube https://www.youtube.com > watch


0:38 Visit https://automobilediagram.com/dodge-durango-2004-2009-fuse-box-diagram/ for a detailed fuse diagram for both interior and under-hood ...
YouTube · AUTOMOTIVE SOLUTIONS · Feb 21, 2018

Fuse Box Diagram Dodge

Fuse-Box.info https://fuse-box.info > Home > Dodge
Fuse box diagram (location and assignment of electrical fuses and relays) for Dodge Durango (2004, 2005, 2006, 2007, 2008, 2009).

Question edited for clarity.
Question moved to the correct vehicle category from 'Misc'.

In the link

https://www.google.com/search?q=2012+Dodge+Durango+speed+sensor+location

..

See the link for answer. 2013 dodge durango 3 6 liter transmission output speed sensor location

Here is the location:

Answer

picREMOVAL - 4.7L
The Camshaft Position Sensor (CMP) on the 4.7L V–8 engine is bolted to the front/top of the right cylinder head (CMP Location—4.7L Engine).

It is easier to remove/install sensor from under vehicle.

Raise and support vehicle.
Disconnect electrical connector at CMP sensor (CMP Location—4.7L Engine).
Remove sensor mounting bolt (CMP Location—4.7L Engine).
Carefully twist sensor from cylinder head.
Check condition of sensor o-ring.

Its in different locations depending on if its 2wd or 4wd. For 2wd its in front of the drice shaft or for 4wd its in the tranfer case, just look for a white shape like box with wires plugged into it and you need a socket to remove it, iam not sure how much it is to replace as the cost varies at different shops.

I have a 2000, there is a speed sensor located in top of the rear axel and I believe another on the tranny housing. Try the rear axel first.

It is acually called the vehicle speed sensor I do believe. It should should be located on the top of your transmission with a wiring harness attached to it. It should also have 1 bolt holding it in also. Whatever you do, do not rotate the gear when you remove it. Try to mark the exact way it came out when you replace the sensor. When you pull the sensor out it will have this gear attached to it which will need to be placed into the new sensor and put back into the vehicle in the same way it came out or you will throw a code and it will not be pretty. Good luck, hopefully I didn't scare you it can be a simple repair just mind your P's and Q's.

If you have the 4.7L..............

The Camshaft Position Sensor (CMP) on the 4.7L V–8 engine is bolted to the front/top of the right cylinder head.