Turn wiper off they stop in midel of windshield , won't go down to bottom of windshield .
Loosen the nut at the bottom of the blades so that the wiper motor will work without moving the blades. cycle the wipers and allow the motor to come to the rest position. Fit the blades and tension the nut. Pull the arms off the windscreen and cycle the wiper motor to run until it stops put the wipers back on the screen and see where they are. IF parked properly then OK but if any where then replace the wiper motor as the sequencing gear inside is out of sync with the wiper action.
SOURCE: Adding coolant to a 1998 Jaguar XK8
if the coolant light is on or comes on when driving you MUST let the car cool down at lest 1 hour before doing anything, after this cool down time lift the hood [u.s.a.] or bonnet [uk] looking from the front of the car on the right hand side towards the back of the engine compartment is the coolant header tank,about 5inch square black in color [u.s.a.] colour [uk] with a large screw top and some rubber pipes coming from it,this should be topped up with coolant right to the neck of the screw cap when you remove the cap to top up the coolant unscrew it slowly as it may be under pressure you don't want hot 212F[u.s.a.] 100C [uk] coolant in your face do you.good luck.
SOURCE: 1999 Chevy Venture, Windshield wipers stop in upright position
You will need to replace the wiper transmission.This is a common problem.
SOURCE: need to install radio antenna on 1999 jaguar xk8
on the base of the antenna mast is a chrome nut (14mm?) unsrew that, then turn radio on , it will eject the guide cable. then insert the new cable, turn radio off and wait like 15sec then the motor will take in the new cable then put the chrome nut back on> thats it
SOURCE: windshield wipers stopped working. What is the
check the fuse box the fuse marked wipers .make sure the fuse is not blown .if not check the wiper motor for electricity if good replace wiper motor
SOURCE: 1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
390 views
Usually answered in minutes!
×