Won't start 2007 Ford Sport Trac won't start. New battery installed. Dash lights work, remote keyless entry works. Won't turn over. Starter won't engage?

Dirty battery cables or faulty starter. Do the lights stay on bright while starting?

if it was a shop that installed it, they unhooked the battery for sure, the next time you start it, turn the key to the on position, and wait for the lights in the instrument cluster to go off, about 45 seconds or so, then start it

kindly pls check the BCM which is located under the left side of the dashboared i hope that will help.

Make sure you don't have an OVERHEATING problem. Engine damage is sure to occur if it's running too hot. don-ohio

The 'Keyless Entry & Burglar Alarm System" is activated. You must 'Disarm' the system using the Keyless Entry Remove (Key Fob) to "Reset" the system. The reason the engine won't start is due to the burglar alarm - it has a "Starter Kill" circuit which is activated when the alarm is activated. The alarm must be DEactivated to DEactivate the 'Starter Kill' circuit.
Another way to start the engine is to get in the car, put the key in the ignition and turn it to 'ON" and wait 3 to 5 minutes until the emergency flashers stop/turn off. Afterward, you should be able to start the engine. NOTE: This does NOT reset the burglar alarm. It will go off again when you enter the vehicle without using the remote/key fob.

on this model you can go through the onboard computer where it tells the tire pressure oil life ect. and change options on your impala keyless system. make sure the keyless entry is turned on. i hope this helps any other questions post back to me.

Dead battery

You can not jump a dead battery ,
dangerous practice.

The click is the starter solenoid

If the battery turns out not to
be the issue,then the solenoid
or the starter

Ok help me understand this. When you say "remote starter" are you refering to the Keyless Entry remote. Assuming your car is equipped with remote start from the factory, if you check engine light is on the remote start is disabled. Is your check engine light on? Do you have multiple Keyless Entry remotes? See if the other one works if you do? It is possible that perticular button on that remote is not working while others are working. You will need to replace it at a dealership.

You can call the ford dealer and give them your VIN and they can give you the code.

180 milli-amps is way to much draw,ford's limit is 50 milli-amps but typically we usually only see around 20-30. Now when you say fuse 2 is that in the under-hood fuse panel or the interior fuse panel? And if this vehicle is a 2007 it may still be under factory warranty which was 36 months or 36000 miles providing that the add on automatic starter is not causing your draw.Which in that case the people who installed it should be responsible for that.