1990 Mazda 626 Logo

Related Topics:

Don Reed Posted on Dec 17, 2013

When warm the car will not run in forward gears but runs fine in reverse

When I put the car in drive it dies but if I put it in reverse, it runs fine

3 Related Answers

Anonymous

  • 1 Answer
  • Posted on Nov 24, 2008

SOURCE: NO REVERSE FORWARD GEARS WORK. IS THERE A BAND AJUSTMENT FOR REVERSE ?IF I PUSH IT OFF IT WORKS BUT SLIPS

I have a 2000 Honda Accord EX, it shifts normal on forward with no problem. Also when the car is cold the reverse gear works just fine, but when the car runs for about few minutes the reverse gear will not work. It will seem as if it wants to go but then if feels like its neutral.

Ad

Anonymous

  • 410 Answers
  • Posted on May 24, 2009

SOURCE: Engine stalls when shifting into any drive gear.

It sounds like your idle air control valve could be going out on you.  The extra stress from being in gear can cause the car to stall out if the IAC valve isn't opperating properly.  The IAC is attached to the throttle body and is normally held on by two screws.  IAC valves are relatively cheap from AutoZone and easy to replace.  That would be my best guess based on your description.  Good luck and let me know if you have any other questions.  Thanks for an honest rating and for using FixYa!

Anonymous

  • 1 Answer
  • Posted on Aug 18, 2010

SOURCE: When put into drive the car shakes and stalls. It

I have a 1989 5-series BMW which sometimes stalls after changing from reverse to drive. It also sometimes shakes when first driving in reverse before changing to drive.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Changed the transmission fluid on my automatic, not vehicle wont go into reverse.

Are you sure you put the correct amount in? Sounds like when it's cold the fluid settles on the bottom. But when it warms up, the fluid starts to travel and not be enough to lube and cool the gears. Check you owners manual or compare what you took out with the amount you put in.
0helpful
2answers

Car will start but put it in gear engine will die

engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com
0helpful
1answer
0helpful
1answer

When warm the car will not run in forward gears but runs fine in reverse

your forward gears unit is stuck, need the check the transmission unit gear system
1helpful
1answer
0helpful
1answer

Cars cranks and runs but dies when put in gear

If it is a Stick shift or an Automatic, the engine speed needs to be at least 750 RPM, after the gear has been selected. Either Forward, or Reverse. Get the Engine "Warmed up", and make the necessary adjustment on the Throttle speed adjuster screw.
Regards,DT
0helpful
1answer

My girlfriend has a 93 olds cutlass ciera and it dies in reverse

When is the last time she had a tune up?
I would start there. Plugs, Wires, Distributor Cap and Rotor. Hope this helps you and thank you for using FixYa!
4helpful
2answers

I have a 1994 Dodge Dakota, no power at low rpms

yes it does if it is reading lets say lower than normal that would explain easy start up and stalling later.the coolant temp sensor has two wires .so if your car warms up and your coolant is about 200 degrees your coolant sensor might say 80 degrees .access to a scanner to check temp would be great.
0helpful
1answer

No drive or reverse when put in those gears !

the fluid is fine its an auto by the way
the car runs fine its like someone took the gearbox out
its like its in netural in every gear it just revs
Not finding what you are looking for?

27 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...