Car wouldnt start replace ignition switch, clutch switch then starter worked for 2 days now starter clicks but wont start left overnight car starter but when turned off wont restart

Try another key, you can also jump the solenoid under the hood on the passenger side, big terminal to the little terminal. Keep your hands clear of moving parts. This test will determine if the starter is bad ( or wiring to starter ) or if your ignition switch or related components are defective.

Check the spark plug. My truck did the same thing and it was because the spark plug had completely been removed.

When it will not crank, a mechanic would check for voltage at the starter, the clutch safety switch, and the key switch.

it can be the ignition switch or the neutral safety switch. put the transmission in neutral to see if it will start, if it does then the neutral safety switch is bad. if not then check your ignition switch

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

If the clutch safty switch is bad - no - pop starting it would not work either..

You most likely have a burnt terminal in your Inside fuse block.Easiest way to check this is to remove the console trim panel next to the drivers side front of console,just pulls loose.Then while trying to start the engine reach down & wiggle the wring going into the front 68way connector.If it takes off & starts to crank you have a burnt terminal in the fuse block.If you remove the front connector (68 Way) there are 2 of these 68 ways in that block.You can look inside at the male terminals you will see one terminal with plastic melted around it.If you see this,that''s your problem!! You will need to find a used Fuse block at junkyard with same Part #.Very important to get same part!! Hope This helps

Its likely that you have either a bad ignition switch or a bad neutral safety switch (if stickshift, clutch switch) Try starting in neutral...if it starts, change neutral switch (jump across clutch switch, check starting in neutral with your foot on the brake) Ignition switch is on top of steering column under dash.

loosen the battery cable.... start the car with a boost.... after it is running... unhook the battery.... if it dies... replace the alternator... if it keeps running... replace the battery.... make sure this is done outside and everyone working on the car is wearing safety glasses

have you checked to see if the alternator is working? If it isn't the battery is being drained. You may have lights and all but the cranking power is drained therefore you don't have enough juice to start it. So check the alternator and if possible do an obd 2 scan at autozone or advance auto