Driver's power seat not working properly on 2004 tahoe

Auto Repair: How to Replace a Power Seat Motor - YouTube

? 1:44
https://www.youtube.com/watch?v=EDh-0rs5Fjo
Oct 26, 2010 - Uploaded by automdvideos
Auto Repair: How to Replace a Power Seat Motor ... 2007 - 2008 Ford Expedition/Lincoln Navigator Driver Bottom Install Video ...2003-2006 Chevy/GMC Seat Cover Install 1 of 3 - eBay Ready ...2000 Ford Explorer Front Seat Track Stuck Motor Repair - Duration: 4:39. by cubmancan 4,959 views. 4:39.
Drivers seat is dead! No power seat or heat. - TheDieselGarage.comwww.thedieselgarage.com/.../96465-drivers-seat-dead-no-power-seat-hea...Mar 22, 2010 - 2003-2005 Chevrolet Avalanche, Silverado, Suburban, Tahoe 2003-2005.... Power seat on driver side didn't work.....passenger did! Neither ...DANG electric seat ' Chevy Truck Forum ' GM Truck Clubwww.gmtruckclub.com/forum/threads/dang-electric-seat.2990/Apr 27, 2006 - 10 posts - ‎7 authors'03 Tahoe My driver seat just stopped, of corse not where I need it, the ... I have a 2003Tahoe and both heated seats are not working. ... with my seat heater on the drivers seat in my 03 Avalanche, it turns ... The driver's side on my Silverado gets way warmer than the passenger side. ... Frozen New Member.Power Seat Problems?? - Tahoe Forum - Che

Check underneath the seat for an inline fuse. It is a glass type fuse in a fuse holder that you have to push and twist to get out.-----------------------------------------------------------------------------
XPROG-M

more than likely it is the power seat switch itself try pushing on theforward button really hard onc and if it now moves get a new switch

I have the exact same problem and I am wondering if you've found the source of the problem??

For $5-$10 you can buy a 12 volt test light at auto store or hardware store if you don't already have one. Multimeter will work too. Probe (poke) wires going to motor for power when you hit switch. Should light up on one, when switch one way, and other wire when switch pushed other way. Just reverses polarity to move motor in different direction. If no power on any, then I'd go to switch and poke for wire with constant power at one of the terminals. If constant source going into switch, but nothing getting to motor, then I'd replace switch.

I think you will have less problems with removing the entire seat, just be careful with the wires, unhook wire harness first.

Not sure how heavy this seat is, and make sure you properly torgue everything down when you re-install for safety in a collision.

You can move the drivers seat back by turning on the power, getting in the seat and position your feet firmly on the fron flor with your back firmly against he seatback, and then engage the switch pushing back - while pushing like hell with your feet. You can actually hear the seat drive shaft turning while the seat moves back. The principle should be the same for moving forward, but pressure would have to be aplide to the back of the seat.

U most certainly have a defective switch, really nothing else can account for this problem.

The front seats I know will work but as far as the back seats they wont because the shape of the truck..

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589