SOURCE: Mazda 626
Hi Janieanip01,
Again we need more imfo....Is the vehicle injection?....If it is you'll have to wait until the fuel rail is re-pressurised before it will start....Crank it for about ten seconds at a time so as not to burn out the starter motor....It may be that the vehicle didn't run out of fuel but instead the pump may have given in....and when did you last replace the fuel fiter?
Regards Johngee10
SOURCE: changing the tail light bulbs on a 2000 mazda 626
The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
SOURCE: 2000 mazda 626 fuel filter location.engine
it should be on the driver side. very hard to get to. look under the air box were the air filter goes.
j.aguilar
SOURCE: where is the starter located on 2000 mazda 626 lx
if u open the hood and stand on the right hand side of the car at the wheel facing the engine its on the right hand side of the gearbox under inlet manifold
117 views
Usually answered in minutes!
×