2000 volvo s80, p04555 evap leak large. any ideas?

sputtering - Volvo Forums - Volvo Enthusiasts Forum ...

volvoforums.com > Volvo Forums - Volvo Enthusiasts Forum > Tags

cluster, engine, instrument, intermittent, s80, sputtering, stalling, volvo, T6 instrument cluster dies, engine sputter/stalls intermittently · jeffs80s. 11-06-2013 10:26 ...

Re: S80 sputtering, won't accelerate - Matthews Volvo Site

www.matthewsvolvosite.com > ... > Volvo S80 Forum

Dec 15, 2010 - 2000 V70R Black, 129,000 miles (Wife's R, getting up there, she won't sell it)! ... The S80 T6 is "just because I could" and it's a fun drive! Top ... S80 T6 2000, codes
Jan 18, 2011
misfires and sputtering 1998 V70
Aug 21, 2009
More results from www.matthewsvolvosite.com

Sputtering And Dying, Please Help - Volvo Forum : Volvo Forums

www.volvo-forums.com > ... > 1G (1998-2006) S80 Forum

Jan 30, 2012 - 4 posts - ‎4 authors
i recently bought a 1999 volvo s80 t6 with 170,000 in august 2011, with "no ... itsputters and dies. i try to start again and it wont. so i disconnect the battery for ... I have a 2000 S80 2.9 and have replaced the TCM and the ABS ... Urgent Transmission Service S80 2000
2 posts
Jul 23, 2011
On My Second New Maf And Still Problems
4 posts
Apr 2, 2006
More results from www.volvo-forums.com

This is a fault for the first O2 sensor, It is important to know the added info scanners provide about the electrical fault detected (can indicate mixtures, heater circuit, slow response or plain electrical fault) Keep in mind depending on the missing info you can have an air leak from the pcv system, evap system or a small hole in the Induction/Intake hoses, What engine do you have?

It has a belt. If cracked, replace it immediately! Go to Matthews Volvo Site and look for: 99' S80 T6 Cam Seal Replacement/ Oil Leak Repair,Timing,PCV

code p0455 refers to evaporative emission (EVAP) system--large leak detected.===causes--hose connections--intake leak-- EVAP canister --EVAP canister purge valve. There is a possibility that the filler hose to the tank is loose or cracked and when you filled the tank it is running out of the cracked hose. The same applies to the hoses from the tank to the canister and back from the fuel manifold. I would pay attention to the purge valve as if it is not working then fuel smells become a problem also

evap emission control system leak ( large ) vent line off of gas tank to engine is leaking gas fumes its best to go to a dealer for this or a shop with a smoke machine tester it pumps smoke into the line to show where the leak is you wont pass inspection with this if they do emissions testing in your state hope this helps

I think it seats on the top frt corner of the engine(follow top radiator hose).
shouldn't be hard to do , you will need torx heads for bolts. Coolant will leak out in small amount , top it up after repair.

In the past we have used starting fluid to find vacuum leaks. Start the engine, let it idle. Spray quick shots of starting fluid at your vacuum lines in isolated areas. When the starting fluid find the vacuum leak the engine will react to it... usually by going up in rpm. Depending on your engine computer, it may stall the engine. Either way you will find your vacuum leak. Get starting fluid or "ether" at Autozone or O'Reilly.

po455 could actually be a loose or deffective gas cap

check to make sure your the fuel cap is on this is a fuel/ small enissions leak near fuel tank/ it could be the( fuel resonator or evap caniste)

The P1132 I believe is a bad mass flow sensor or a vaccum leak