No heat does not change from ac where is it and can i take it out and move the switch to heat??
Yes near the passenger side of the car close to the floor is the actuator, it is about 6 inches away from your blower motor closer to the center of the car, there are three screws holding it in and one is very difficult. Once you pull it out you can turn the door by hand, just have the heat blowing when you do it so you know when you have it on heat. after you have done this to get heat fixed for now watch your actuator as you turn it from cold to heat and back again, "if it turns then your blender door is the issue. if it doesn't then check the voltage going to it, if you do not have any pull the switch out and check for voltage there. If your actuator doesn't move and you have voltage, the actuator is the issue. If you have no voltage at the actuator and you have voltage to the switch it is the switch that is broken. hope this helps you.
I’m happy to assist further over the phone at https://www.6ya.com/expert/brock_d67526d2a834c47e
Could be the airbox door actuator control is'nt working. What type controls does the car use? electric, or levers?
SOURCE: Changing 1996 Lexus LS400 headlight bulb.
you have to remove the head lamp. there are 4 bolts that hold it in. you will have to remove ouyer marker lens first.1 screw on top and pull forward. clips hold lens pretty tight.
SOURCE: Replace/fix starter on 1991 Lexus LS400
Not too bad. Not much room, just enough to drop the starter. It is probably easier to go up through exhaust if you can get your exhaust shield off the manifold .
http://howtobyme.blogspot.in/2012/05/2004-toyota-tundra-oil-gauge-and-temp.html
---------
Toyota 4Runner: Temperature Gauge Sensor
http://technoanswers.blogspot.in/2012/04/toyota-4runner-temperature-gauge-sensor.html
-----------
Temperature gauge sits over half way mark?
http://schematicsdiagram.blogspot.in/2012/04/temperature-gauge-sits-over-half-way.html
----------
Heater blows intermittently and temp gauge goes erratic?
http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html
-------------
No heat on Oldsmobile Silhouette?
http://technoanswers.blogspot.in/2012/02/no-heat-on-oldsmobile-silhouette.html
-------------
Temperature gauge does not move and no heat when heater is ON?
http://technoanswers.blogspot.com/2012/01/temperature-gauge-does-not-move-and-no.html
----------
Temperature gauge keeps fluctuating up and down close to red?
http://technoanswers.blogspot.com/2012/01/temperature-gauge-keeps-fluctuating-up.html
-----------
Temperature gauge on the dash quit working on Pontiac Grand
Prix?
http://technoanswers.blogspot.com/2012/01/temperature-gauge-on-dash-quit-working.html
-----------
Dodge neon gauges not working?
http://technoanswers.blogspot.in/2012/02/dodge-neon-gauges-not-working.html
---------
Heater blows cold?
http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html
----------
Heat blows cold on drivers side and hot on
passenger side?
http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html
-----------
1992 Lexus LS400: Engine overheats,
Antifreeze out of reservoir and heater Blows Cold Air?
http://whatisbyme.blogspot.in/2012/05/1992-lexus-ls400-engine-overheats.html
-----------
These details will help.
Thanks.
Air
Temperature Control Blend Door Failure No Heat or no AC (dependes on
where door sticks)
In
all modern cars there is a tiny DC electric motor driven gear drive
that moves a plastic door that blends heated and cooled air from the
AC and the heater core, this is called (interestedly enough) the air
temperature control blend door actuator. The motor that moves this
door fails because the door starts sticking from warping, most common
complaint is no heat but it can be no AC as well. To replace these
parts (blend door and blend door actuator) you must remove the entire
dash from the car. Always have this problem confirmed by a dealer or
qualified repair shop as it is a very expensive repair.
Other causes of no heat in the cabin are engine thermostats that are stuck open (engine runs cold) or air bubbles in the cooling system.
181 views
Usually answered in minutes!
the thermostat is working inlet and outlet hoses for heater core are hot
Add a Commentjust can not find the acuator tp change/remove it
×