SOURCE: 1987 toyota supra.
hmm. . . . go to tuner shops. . . for sure if they dont have one they can order 1 form japan. . . it maybe an aftermarket clutch but why not. . . they last longer. . . 8)
SOURCE: Timing Dpecs for Toyota Supra 87 6 cylinder
1987 non-turbo: 10 deg Before Top Dead Center (BTDC) @700 rpm
1987 Turbo: 10 deg BTDC @650 rpm.
To set the timing, you will need to connect a jumper wire between terminals E1 and TE1 on the diagnostic terminal. This diagnostic terminal is located just aft of the engine compartment fuse box. It is a black plastic box marked "diagnostic" on the cover, which flips open to reveal the terminals inside. There is a diagram on the inside of the cover which explains the terminal positions. On the Turbo model, you need to remove the forward section of the engine cover to gain access to the number one spark plug wire.
SOURCE: replacing fuel pump do i need to remove tank 1993
No, you don't have to drain the fuel tank. All you have to do is relieve the fuel pressure. If your car will start, remove the fuse or relay for the fuel pump and start the car. Let it idle until it stalls. Then turn off the key and remove the negative battery cable (to prevent sparks while you work).
I hope this helps.
Testimonial: "cheers mate "
SOURCE: how much freon does a
Your vehicle is old and uses R-12 refrigerant. The handling, importation, exportation, sale and use of R-12 has been outlawed by the U.S. EPA in Section 609. The only exception to this is for those who are EPA 609 certified. Even at that, R-12 currently costs about $6,000 for a 30-pound can (about $200 a pound).
With that being said, unless you find a repair manual from pre-1991, you will not be able to find the R-12 spec - only directions for R134a retrofit and the spec for that.
If your system is R134A retrofitted, let me know and I can give you the specification for that.
105 views
Usually answered in minutes!
×