2008 Volkswagen Passat Logo
J
Jason Beacom Posted on Dec 09, 2013

What is exclamation mark on the MFD of my 2008 passat

Car sputters and won't go past 2000 rpm even with the pedal floored. Doesn't right itself even after letting it idle for a while. Temp has been -40C for a few days.

1 Answer

ultiman_2k50

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 9 Answers
  • Posted on Dec 09, 2013
ultiman_2k50
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jan 24, 2011
Answers
9
Questions
0
Helped
2554
Points
17

Minus 40? Well is the water coolant frozen? Surprised its starting at that temperature. The oil would be thicker when cold. Modern cars are more trouble than older

5 Related Answers

Anonymous

  • 84 Answers
  • Posted on Dec 24, 2008

SOURCE: 1999 passat tdi power fault

Air mass sensor, almost never shows codes but always makes the vehicle loose power !! cheaper from vw than pattern and more reliable

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jun 24, 2009

SOURCE: The clutch pedal on my passat stayed close to floor

sounds like a problem with the hydraulic clutch, either the master or slave cylinder was bypassing fluid and causing the low pedal.

Anonymous

  • 77 Answers
  • Posted on Jul 08, 2009

SOURCE: Car starts fine..Idle is fast...stalls after car warms up

Check for vacuum leaks. Also try cleaning the ISV.


If that doesnt work go to vwvortex.com and post your issue there

Anonymous

  • 62 Answers
  • Posted on Jul 11, 2009

SOURCE: 1999 VW Passat low idle

replace your fuel filter first. If that does not do it, then try an air-flow meter. (if the check engine light is on it may be an airflow meter.

Anonymous

  • 566 Answers
  • Posted on Dec 25, 2009

SOURCE: 2008 beetle dash light on with a aexclamation mark

hi from uk this light is the tyre pressure monitoring system it is telling you that one or more tyres pressures are under inflation so! if you have not checked them weekly ? for your own safety you should may i suggest you check and inflate to correct pressure of all tyres inc spare ! obviously if one tyre is very low ? keep an eye on it? in case it has a slow leak/puncture ? ps the horse shoe is a low pressure tyre symbol ? best wishes from uk and merry xmas !

Testimonial: "thank you so very much , very helpful ...[happy holidays]"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

My Chevrolet impala 2008 won't drive or reverse, never gave me any warnings regarding transmission issues

You either need to change the throttle position sensor or the gas pedal I got a 2008 Impala I had to put a new gas pedal in in so it would function properly
0helpful
1answer

My 2003 Honda Civic lx wonā€™t accelerate when I floor it it doesnā€™t go over 3000 rpms When it is I park it idols and and between 1k and 2k rpm it sputters when in park

You may have a bad catalytic converter. They start coming apart and plug your exhaust. They cause all kinds of run problems.
0helpful
1answer

My 97 Saturn SL2 won't go past 30 mph. Even with

I guess my first question would be - are you saying it is slipping in 3rd gear ? If you push the gas pedal to the floor it should downshift into a lower gear.
If it is slipping, or not upshifting into 3rd gear, I'm afraid chances are the transmission is toast.
You can take it to a couple of shops for estimates but they will probably want to pull the pan and take a look inside.
0helpful
1answer

My 2000 cavalier loses power when the steering wheel is turned right

You have a problem in the engine wiring harness where it goes through the firewall, check for chafed and damaged wires.
0helpful
3answers

06 titan truck won't accelerate even when the gas

If the engine RPM's increase when the gas pedal is floored, you have a transmission problem or a problem with your shift cables.

If the engine RPM's don't change when the gas pedal is floored, you have a throttle pedal cable problem or throttle body problem.

You will need an experienced mechanic to diagnose this problem as it is very dangerous to operate the vehicle under these conditions.

Iā€™m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

0helpful
3answers

The car won't start let alone keep running. The battery light was on for awhile but the car was running fine. Then I was driving and it just started sputtering and died and even when I jump it it only...

Get the battery & the alternator checked (Autozone, O'reilly's or even Pep Boys can do that for free). If the alternator is out or going out, it's not charging your battery - that means everything electrical in your car is now trying to run directly off the battery & draining it (it doesn't take long - especially if the lights or A/C is on). If those check out ok, take it into a mechanic & have them run a diagnostic - you may have a relay out. Good Luck.
0helpful
1answer

What does MFD mean at the top of my speedometer display in my 2008 VW Passat?

I have a VW Passat estate 2008, the dashboard screen has now got the letters MFD Speed warning on it, it came on when I was in a queue of traffic doing about 15mph. Does anyone know what this means and what I can do about it?
25helpful
4answers

Hi i have a 1999 vw passat 2.8 v6 and the problem is that my car does not accelerate as normal,it goes up to 1500 rpm and 2000 rpm and it goes up and down,if i step more on gas it passes the 2000rpm but...

p1545 is a throttle control malfuction code

You can try to reset the throttle body by opening the hood and drivers door then turning your key to the accessory position. You will hear the throttle body whir and click. It may take up to two minutes. Afterward, the car will relearn your habit of driving and adjust accordingly.
0helpful
1answer

Chrysler 3.5 won`t rev past 2500 rpm?

remove the aircleaner intake hose and, check the intake air control flap for free movement
Not finding what you are looking for?

329 views

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Bradley
Bradley

Level 2 Expert

105 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...