Https://s10.postimg.org/h8lyo7ind/park_lamps.jpg
Click on the link for diagram.
Does the fuse blow as soon as you plug it in or only after you turn on lamps?
Your front and rear park lamps and tag lamps all get voltage from the same source. When testing, did you unplug the front park lamps to see if fuse still blows? You don't have to blow all your fuses, you can a test light between fuse terminals, If the lite comes on, the circuit is still going to ground.
SOURCE: 1994 accord, dash and tail lights wont work
chk. headlight switch, my guess thats what it is.
SOURCE: 1994 honda accord. meter/and tail lights
Did you see the Small Black Squares inside the Fuse Relay Box under the Hood? These are Relays. There should be a Relay that says "Illumination" OR "Lights" around this area. Change this Relay and it should be ok. They just Cost a Couple of Bucks. Please Rate my Response, I need all the Help that I can get ! Thanks!
SOURCE: where is the fuse or fuses for the tail lights on acura mdx.
there's one under the hood another under the dash on the drivers side and possibly one under the dash on the pass. side also. check your owners manual if you have one it should tell you where they're at.
SOURCE: how to factory wire fog lights on a 2000 ford
This is a common problem on 97-00 MY trucks, regardless of the trim level ( XL, XLT, Lariat ).
If you install the fog lamp fuse in the BJB ( aka Battery Junction Box, Engine Compartment fuse panel ) Fuse # 9 ( 15 A fuse ) and jumper the normally open contacts in the fog lamp relay socket ( see diagram below ) the fog lamps should illuminate ( to confirm what you have doing on ).
The problem usually is the main headlamp switch to the BJB is not in place ( this is the yellow wire from the main headlamp switch connector to the relay socket pin #1 ).
One easy route is to make an aux lighting relay & harness, or purchase one online. With this, you can cut the factory ends and attach them to the harness you purchased. There is an air inlet next to where the steering wheel column runs through the firewall. This would give you an easy route to the fog lamp switch. The fog lamp switch, you can buy the factory one, and change the yellow wire from the connector to your added relay, or just add a switch for this function.
This will give you an idea of what the DIY relay and harness would look like.
Hope this helps, more than confuses at this point
205 views
Usually answered in minutes!
×