SOURCE: Replace license plate light 2005 Hyundai Accent
A slightly better set of instructions might help you. Mine is a 2003 Accent. You have to remove the access panel that covers the lamps and the wiper control. Remove the phillips screws along the bottom of the panel (closest to the floor of the trunk when the lid is closed). Then remove the two screws that hold the brackets onto which the two strings are linked which are used to raise the rear deck slightly when the trunk opens. Next, there is a small cover underneath the rear wiper (about 2 inches square) that you need to carefully pry off using a small flat head screw driver via the indents on the lower side of the plastic cover. Inside you will find a 10mm bolt; use a ratchet to remove the bolt. Next, using a small flat head screw driver, carefully pry the middle section of moulding between the panel you are removing and the molding that covers the top portion of the back glass. There are two clips at the base of each middle moulding piece closest to the panel you are removing. Once those pop free, grab the panel at the bottom and firmly but gently pull away from the car body to pop free the two retaining clips holding the moulding to the car body. Finally, use one hand to grasp the panel from the bottom and the other to help help slide the panel "up" towards the glass (top of the car). The panel's top is flanged, and must slide up and away from the lip on which it sits. With the panel removed, grasp the white socket that holds the bulb and with gentle pressure turn it counter clockwise about 40 degrees and then pull the socket out. The replacement bulb is a type 168. Reverse these instructions to assemble, making sure in the end to push all retaining clips back into place until you hear them "catch" and hold the panel firm;y against the car body so that you do not get vibration noise.
SOURCE: replacing rear wheel bearings on 1999 hyundai sonata
with out sealed hub ,
with disk brakes
SOURCE: Rear wheel bearings on Hyundai Accent
no i do not believe they are press in there are held in by a seal try www.autozone.com to see if they have your car listed if they do you will be able to get a diagram showing you how they come a part.
SOURCE: 2003 hyundai elantra gls front wheel stud broke
grab a large punch and hammer and knock out the old broken one. Push the new one in and re tighten. This will pull it into place and because it has splines it should not spin while doing so.
Testimonial: "excellent advice"
SOURCE: Front wheel stud replacement for a 2006 Hyundai Sonata GL.
grind a flat spot on the round head of the new stud this should give enough clearance to install it. don't pull the hub this will damage the bearing.
914 views
Usually answered in minutes!
×