Nissan almera problems

Question edited for full 'year make model'.
Question moved to Nissan.

You need a mechanic with a scan tool to see why. A pro grade scanner can record what happens at the moment it shuts off.

It appears to be a known issue.

https://www.google.com/search?q=2004+nissan+almera+tino+cuts+out+while+driving

..

2001 Nissan Almera Tino V10 Service Repair Workshop Manual DOWNLOAD


for the easy solution download the pdf file

if you are under the car it should be on the firewall side. It is black piece or a light grey color.

Mine just failed emissions test garage said its burning oil what is the soulution

Try the following:

"KEY FOB PROGRAMMING
NISSAN
SYSTEM DESCRIPTION
The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and hazard reminder. When the doors are locked and
unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed.
ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II
Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning
lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key?s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key?s for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds."

hi i am not 100% sure but i think it is the P11 144 gearbox its used with the almera qg15de engine. i think it is also used in a primera and almera tino of the same years.

Try this: With the ignition ON but radio OFF, press in and hold the INFO button and turn volume control until the menu appears. Now choose CONFIRMATION and Enter. Go down and select SERVICE and press Enter. Select RESET and then Enter. Backup to the main menu and now turn ignition off. This should remove it.

If you spray silicone in the tracks from the top open window and the speed changes faster I would say the channels are too tight. If no change then the voltage at the motor needs to be checked at 13+ volts. If not then the wiring at the door bend needs to be checked for fraying. If a garage does this job, then they should fix it right. It is not right. You paid for it.

Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.

YEs but if you are going to do some secrifice on your luck of car model from front,

otherwise its impossible,

you can get this from older car dealer or service center,

TNX