Aveo key programing 2007 fob key
SOURCE: 2007 aveo fuel line
look under car at the rear where gas tank is, you should see 2 or 3 small metal lines coming down from thr front of the tank, then you can follow those to the engine.
IF you are looking for a fuel filter that is external, like the older cars have, forget it. The filter is part of the fuel pump, which is located IN the fuel tank. You would need to remove the pump to replace the filter, I haven't had to do that yet but you "may" be able to access it by removing the carpet in the rear to see if there is a access panel that you can remove to get to the top of the pump.
Prices for the complete pump, which may need replacing, at Napaonline.com lists at $464, you can find the same pumps on Ebay for around $100, give or take a few $.
Someone should have just the filter but since you have to remove the pump to get to it, it may be a good idea to replace the complete pump, as these cars were not the best made, they do start having problems at or before 50,000 miles.
Also, see Q on timing belt replacement, they can/do break after/before that milage also, when they break the engine is usually worthless, replace it now and every 40K or 50K after that for your own sake, see the link I posted for that procedure.
SOURCE: how to program key fob. I have the fobs.
Transmitter Programming Procedure
Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the door unlock switch.
While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on the transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of the transmitter.
Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation.
Good luck
SOURCE: what is the spark plug gap on a 2007 Chevy Aveo
Easy its .044
caution gap is not adjustable on some plugs.
torque plugs to 18 ft lbs..
SOURCE: 1999 Chevy silverado z71trying to program a new key fob
Use this procedure for New Body Style.
1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
630 views
Usually answered in minutes!
×