1988 Chevy S10 Durango Pickup, Won't start will fire

Question edited for clarity.
Question moved to correct model category.

You need an auto electrician with a pro grade scan tool computer to diagnose the charging circuit and battery drain.

https://www.google.com/search?q=auto+electrician+near+me

..

Duplicated question

Hello, just had this problem myself. Check your EGR valve by pulling the vacume line off and pushing up under the valve put your finger over the vacume line hole and release the valve, if it returns to normal position then its bad if not its good. If its bad it needs replaced. Mine did the exact same thing and thats what it was. Hope this helps

What engine? If it's a 4.3, the order is 1-6-5-4-3-2

1999 Chevrolet S10/T10 P/U 4.3 liter V-6 VIN "W"



Hope this helps (remember to rate and comment this).

think your starter motor is no good or the battery is flat ,try charging the battery for a couple of days as well

I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months.
I assume you have a 4.3L and not the 2.2L?

For the 4.3L:
Firing Order:
1-6-5-4-3-2

Cylinders:
6-----------5
4-----------3
2-----------1
(front of vehicle)

Distributor:
coil wire-->
-----6------->............<--------5-------
-----4------->............<--------1-------
-----2------->............<--------3-------
............(front of vehicle)

Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

the three thing cars need to fire up are gas,air, and spark check these three if they are fine then it might be the starter or something else

bad dis cap or rotor maby a bad plug wire or valve sticking or out of adjusment