Change the license plate lights
SOURCE: licence light replacement 1996 Cadillac Deville
remove your license and behind it you will find i think two screws then remove that panel and you should be able to get to it.
SOURCE: bulb burnt out on license plate
you need the remove the lighting fixture first to access the bulbs.
SOURCE: fuel filter replacement 1993 Cadillac Deville
hello. it should be located under your car on a line that's coming off your fuel tank and yes you can do this your self very easy to do ,you'll need a few box/open ended wrenches that's it you'll need to check the fitting or the nut on each side of the filter to see what the sizes are,befor removing the filter you'll want to take off your gas cap and remove your neg battery cable ,not when you find the filter it'll have nut on each side all you have to do it loosen them but make sure that you don't break the fuel line or kink it and after you have both sides loose then just finish turning them off and there you go the filter is off, nope no removing the gas tank some newer models you do and the filter is attached to your fuel pump and don't need replaced but for your car and year you wont need to remove the tank. good luck
SOURCE: problem with 1993 cadillac deville sss light comes
This problem only exists on cars with the electronic suspension option. Service SSS light comes on when the valving motor in the strut fails to move as commanded. This is usually signs of a failing strut. If you clear the code, it may function OK for a time but its days are probably numbered. New replacements are only available through GM and may run in excess of $500 each. Cadillac service bulletin # 00-03-11-001A has details of replacing these with standard struts and disabling the SSS computer.
SOURCE: replace the license plate light bulb-'99 cad
Hello,
Please follow the instructions below carefully to change the bulbs in the licence plate of your cad deville;
1.All you have to do is put a flat blade screw driver on the right side of the bulb housing and gently push to the left. This will release the catch holding it in and it will drop out and down on the end of its wiring connector.
2.1/4 turn the bulb and remove. Replace the bulb and just put the housing back into the opening left side first, then just push up on the right side till you hear a click. Takes about 1 min per light. Works for all Deville types from 99-08
Good luck.
103 views
Usually answered in minutes!
×