1996 Subaru Legacy Logo

Related Topics:

Posted on May 08, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Engine light on/off rough acceleration

1996 Subaru Legacy 122,000 mi. Engine light is on and off frequently during operating. When flashing engine is rough then will smooth out. But light stays on. Up inclines very rough at times I have changed wires, plugs air & fuel filter. Current measure's across all 4 wires reads 11 amps from module to all four plugs. Read-out say's problem with number 4 cylinder. Re-set is good for a few days?

  • Anonymous May 08, 2009

    what engine is in the car 2.2 or 2.5 if its a 2.2 drop the front ex pipe and inspect ths valve glides

×

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Expert 382 Answers
  • Posted on May 14, 2009
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Jan 23, 2009
Answers
382
Questions
0
Helped
157474
Points
710

I would have the coil tested again. May have a bad ground. Also check all major grounds, body and motor.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have subaru legacy model 2010 .i have frequent the engine stops when i am breaking to slow down in a trafic jam,the car vibrate showing engine stops if i press on the accelerator the motor will resu

Could be bad EGR valve or vacuum leak. Egr valve, depending on whether it is stuck open or closed can act like the old choke thermostats on the carburator system making the vehicle run and idle rough when it is cold OR hot but normally only one or the other. Will run fine cold but rough once it's hot or rough when cold and fine when hot. Check or have someone check for any trouble codes in the system. It can hold codes and not make the check engine light come on and may help diagnose the problem.
0helpful
1answer

My code is 3 short check engine light flashes 91 subaru legacy

No idea here no experiance but try asking at the dealers as it could be something simple like a oxygen sensor failure as these older cars are not electronicly loaded
0helpful
1answer

91 Subaru Legacy L+, 2.2 liter, mfi, no turbo, distributorless ignition. Check Engine light on, idles real rough (but runs fine at speed). I can't convince it to give me any flash codes. What is the...

Read Memory Mode : used to pull codes which have been stored in memory. It is most effective in detecting poor contact of wiring harness connectors. To enter this mode, connect the read memory connector with the ignition ON . D Mode : used to diagnose and test the entire injection system. To enter this mode connect the test mode connector with the ignition ON . On the Legacy and SVX, the ignition must be ON with the engine running. F-Check Mode : used to measure the performance characteristics of the injection system components. When working in this mode, a Select Monitor or equivalent scan tool is required. U Check Mode : operates during normal engine operation. It signals the driver using the MIL only when components necessary for start-up and drive are faulty. The read memory and test connectors must be disconnected with the ignition ON for this mode to be operational.
0helpful
1answer
0helpful
1answer

My 1996 Subaru Legacy Outback, 2.5L, engine is making a sound

No the timing belt have been well replace or else the won't start.Well the timing must be check with a timing light and do the adjustment if necessary
0helpful
1answer

Temperature gauge shows hot but the engine is normal operating te

replace temp sensor for the emission system. there are two on the engine.
Not finding what you are looking for?

408 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...