SOURCE: need firing order on a 1996 dodge ram v8
The order should be stamped on your intake manifold right under the air cleaner.
My '97 1500, 5.2, 318 firing order is 1-8-4-3-6-5-7-2
Hope this helps
SOURCE: 2001 dodge ram 1500 v8 spark plug wire diagram
the firing order is 1 8 4 3 6 5 7 2 clockwise around the cap
SOURCE: location of oxygen sensor
I believe you may have three (3) O2 sensor, (2) of the sensor is on ether side of the exhaust down pipe and some times called up stream O2 sensor, the third O2 sensor know to some as the down stream O2 and is after the Catalytic converter.
The up stream O2 monitors the left and right side banks and sends signals to the ECM to make the adjustments to the injectors to keep the proper air/fuel ratio.
The down stream O2 monitors the catalytic converter and sends signal to the ECM if the catalytic converter has gone bad.
Good luck and hope this helps. If you get it scanned at Auto Zone, they should be able to let you know which O2 has gone bad so as to not change all three. You could always check the wire harness to the down stream O2 for corrosion. Keep me posted
SOURCE: Could you tell me where I can locate the IAT
Here is the location ...
1 - LEFT SIDE OF THROTTLE BODY
2 - ELEC. CONNECT.
3 - IAT SENSOR
4 - RELEASE TAB
SOURCE: had u joint repair on 98 dodge ram 1500 v8 now have trans leak?
I just replaced my front ujoint for the 2nd time and yes when you pull the outer axle to replace the u joint and then reinstall the axle it seems to dislodge or screw up the seal. the 1st time i had a shop do it and they fixed the seal but now its on me
154 views
Usually answered in minutes!
×