I have 1995 Chevrolet Lumina van 3.8L V6 it snapped the serpentine belt, over heated know it will not start. The belt rapped a round the. crankshaft pulley

Search Results

images for diagram on how to replace a serpentine
How To Install Replace Serpentine Belt Oldsmobile Alero 99 ...? 3:33https://www.youtube.com/watch?v=jkzXTt43uwwFeb 9, 2012 - Uploaded by 1A Auto PartsHow To Install Replace Serpentine Belt Oldsmobile Alero 99-04 2.4L .... There should be a belt routing diagram on the frame rail or under side ...serpentine belt install 3.1/ 3.4 v6 - YouTube? 4:00https://www.youtube.com/watch?v=GYoWuvEZ2DcMay 6, 2013 - Uploaded by JoeTheAutoGuythis a serpentine belt install video on a 3.1 liter gm v6 , 3.4 liters are the same in ... Replacing the alternator or serpentine on anyOldsmobile Alero 99-04 3.4 Liter ... Serpentine Belt Replacement 1995-2005 Chevrolet Cavalier .

I've had the 3100 v6 chev lumina car but not the van, the pcv valve is located in the front valve cover to the right hand side.

Belt tensioner problem or bad belt

It's not really something u can do in your driveway if u don't know much about cars but this will help ya out take off sepentine belt with 15mm wrech at the tensioner take off passenger side tire u will need to take off the crank pully the big one at the very bottom bolt Is roughly a 7/8 head no the bolt u will need a crank pully puller and the sensor will be on the right an u will need a 10 mm socket to remove it good luck

Remove the old belt
Measure it
Convert to metric
Go to Auto Parts Store-buy correct belt

One -- it's a serpentine belt.

Charlie

Check the serpentine belt. The belt runs the alternator, water pump and power steering. Make sure the belt is on right and all the accessory like the water pump and alternator is spinning in the direction there supost to be. There should be a sticker under the hood or on the radiator shroud to how the belt is routed through the pulleys. Good luck and keep me posted.

no torque, just snug it up untill it is tight !

Check the crank sensor probably when you replaced the timing belt you could have either not put the crank signal ring in correctly or damaged the crank sensor.

you will have to get ahold of a book for it or go to a junkyard and find one like yours and get the belt routing decal