Replacing bad camshaft position sensor

http://www.bing.com/images/search?q=change+the+pressure+control+solenoid+on+my+2003+Pontiac+Bonneville+v6+3800&FORM=HDRSC2

http://www.bing.com/videos/search?q=change+the+pressure+control+solenoid+on+my+2003+Pontiac+Bonneville+v6+3800&FORM=HDRSC3

googling that o2 sensor seems its comes with a pigtail an connector just about a foot away an not meant to be repaired.
kinda like the one in this picture . yes?
http://onea-ebay-images.s3.amazonaws.com/EOS/1AEOS01029.jpg

Starter should be in the front (3800?), and I cannot recall, but some of these V6's are blocked by the front exh manifold which you have to dael with to gain access

Here is a link with a diagram about half way down the page that points out the sensor as number 8. It looks like it should be near the oil filter just up and over a bit. There is some good info on this page to that may help. Good luck! Have a great day!
Servicing GM 3800 V6 Engines Underhood Service

Check that fuel pressure after warmed up & check injectors with noid lights to see if they're firing warm

Possible bad sending unit or shorted sending unit wiring.

Follow the top radiator hose down. It will connect to the engine. At the point that it connects to the engine is where the thermostat is located. This thermostat cover will have two bolts. Some of the 3800 engines have a temp sensor in the housing. You will not have to mess with the sensor. The housing will have 2 bolts that hold it on. Remove the two bolts and the housing will lift off. And the thermostat will be under the housing. Replace the thermostat. And reinstall the housing.

Vehicle speed sensor. In the transmission by the passenger side CV shaft.

Look for a Bad Plug in on the harness, and trace the harness backwards looking for chafing that can cause leak off and voltage reduction.
Regards,DT

Its on the right side of the camshaft cover. you will need to remove the right cover to pull.