The exterior mirrors:
- are controlled by power controls on the LH front door trim panel.
- are of a foldaway design.
- may contain turn signal indicators.
- may be heated when the heated back window glass is activated.
- may have a programmable recall memory option.
Driver Seat Module
The power driver seat and power exterior mirrors are controlled by the driver seat module (DSM) only when the vehicle is equipped with the programmable/recall memory option.
---------------------------------------------------------------------
Power Exterior Mirror Operation
The power exterior mirrors are controlled by the DSM and are operational all the time, whether the ignition switch is on or off. Using the power exterior mirror switch, the driver can adjust the driver and passenger exterior mirrors four ways.
-----------------------------------------------------
Visual Inspection Chart
Mechanical
Electrical
- Exterior mirror(s)
- Interior mirror
- Central junction box (CJB) fuse
- Circuitry
- Exterior mirror control switch
- Exterior mirror motor
- Interior mirror
- Driver seat module (DSM)
- Memory set switch
----------------------------------------------------------------------------------
- If the vehicle is equipped with memory exterior mirrors and the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel. Select the vehicle to be tested from the diagnostic tool menu.
- Check to make sure the program card is correctly installed.
- Check the connections to the vehicle.
- Check the ignition switch position.
-------------------------------------------------------------------------------------
- The mirrors are inoperative
- Circuitry.
- Central junction box (CJB) fuse.
- Exterior mirror control switch.
I put direct power to the mirrors and its working
I check the intirior switch and I dont fined any problem
if you khow were I can find the diagrms?
Thanks again
I don't have access to those wiring diagrams. I think if you induced the power at the control switch leads and it worked, it's probably a bad switch. Using this method, you would have verified the wired isn't cut between the switch and mirror. My favorite test method is to go to the junk yard and pull a used part. If it works in my vehicle then my part was bad. (sometimes I'll get a bad part from the junk yard though)
If it's not the fuse, I can only think of the following:
1) Interior switch is bad
2) Mirror motor is bad
3) Electrical wire between switch and mirror is disconnected or cut somewhere.
You'd need a voltage tester to determine the exact problem area.
×