Does any one know where the actuator is on a 20011 1.6petrol caddy.PLEASE.
ESP is the electronic gas pedal itself. Housed within it is the ESP controller (ECU). Check if your floor mat is hindering the pedal.
SOURCE: vw caddy 2001 TDI
Your car goes in "limp mode"!!!
If you scan the EDC-15P engine control unit with a VAG or KTS -BOSCH diagnosis tool you will find this:
"Fault code: P1557 - Turbo Boost pressure control exceeded"
You must try follows if you are able to do this:
1. Engine stopped and ignition switch off. Check all pneumatic connections and hoses between turbocharger actuator = pressure unit for boost-pressure control, boost-pressure control solenoid valve, vacuum reservoir, EGR control solenoid valve, intake-manifold flap solenoid valve, EGR valve with throttle - part of intake manifold. Also the vacuum connection between tandem pump and brake booster. If you find something wrong replace parts. If not go to step 2.
2. Extract the hose of the turbocharger actuator = pressure unit for boost-pressure control part of turbocharger. Instead of the original hose you must place another 1 meter long hose with the same inside diameter, and then you check to inspire yourself the air from the other one extremity of this hose. The mechanical connecting rod of the turbocharger actuator must have a smooth and whole motion. If you can do that with your mouth, then you must replace the boost-pressure control solenoid valve. If you can not reach this with your mouth, then you go to step 3.
3. This is the most difficult work. The problem is that the soot particles deposits inside the turbocharger plugging the variable nozzle geometry mechanism = adjustable vanes of the turbine. If the turbocharger actuator is not able to adjust the turbine vanes the charge air pressure increase too much and ECU (engine control unit) go in "limp mode" = engine protection software. As a result the "limp mode" engine still running until you turn the engine off (ignition switch off) and back on when the "limp mode" is deactivated, but the fault ("Fault code: P1557 - Turbo Boost pressure control exceeded") still remain in ECU memory !!!
4. You must be able to extract the turbo from the engine and then to disassemble the turbocharger, clean inside adjustable vanes mechanism and refit all.
It is some work to do here, but after that you will be full satisfied! NO MORE "LIMP MODE"!!!
SOURCE: vw caddy fuse box
i have a vw caddy 08 plate had about 3 months and the screen wash spray my heater 1 to 4 and parrot bluetooth have just stoped working at same time have had it come back on while drivind and was fine but now its all stoped again please help
SOURCE: vw caddy 2006 heater blower switch only works on 4
I have the same problem on my Caddy /07. Switch only works on #4. Seems they should have supplied switches without faults. Any one know how to remove the dash switch?
1,679 views
Usually answered in minutes!
×