At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
My wipers just stoped working in my 2002 corvette. i checked the fuse and its fine. The washer fliud pumps and sprays but wipers dont move and make no noise...? Any help
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
open your hood and get close to your washer fluid reservoir and make someone pull washer switch for you if you dont hear any reaction from you fluid pump locates around reservoir means you need to replace that little pump if you hear pump is working but dont spray check clugged spray nozzles or leak some where between reservoir to nozzles inspect lines and check washer system fuse!
Can you hear the washer pump running when you operate the washer switch? The washer pump is in the bottom (side) of the washer fluid reservoir. You should hear it running. If not, you can disconnect the wire connector at the pump and use a test light to check to see if there is power and ground at the connector when you operate the switch. If there is power and ground, replace the washer pump motor. If there is no power or ground, you most likely have a bad washer control switch. (You have to replace the entire Multifunction Switch)
If you can hear the pump running, check for washer fluid pouring on the ground. If this is the case, you have a broken hose between the washer pump and the jets that spray on your windshield.
Also note that there is no way possible that your problem could be CAUSED by a fuse!
For more information on this subject, please review this article: Where's The Fuse?
follow the hoses to the hood or wiper arm (i dont know where your spray nozzles are)and disconnect hem and press the spray button. if it sprays your nozzles are plugged, if not its your pump motor.
sounds like a bad pump, the fuse for the washers is the same as the wipers, check connection at pump and make sure washer fluid is not frozen if all checks ok. then replace the pump. hope this helps.
well check to hear if you hear the wiper motor working if you do look at the arm take the end cap off loosen the bolt if you here the motor running/tighten them bak up if you do not here the motor check fuse under the dash and inthe engine compartment and replace fuse or fuses/ please rate my response thank you very much
when you turn on the sprayer you should hear a pump motor running, try this with the engine off and key on so u can hear better. if u dont hear the pump then check the fuse if its ok then u will need a new windshield washer pump. if the pump is running when u activate it check for a leak in the lines. if you hold the washer button down long enough and the pump is running then you will see washerfluid leaking from somewhare. have hood raised when doing this so you can see better.
u washer pump motor went out i suggest taking it to a dealer
1
Inspect
Fuse
Corroded, burned, or shorted fuse may be interupting power source.
2
Inspect
Windshield Wiper Switch
Faulty wiper switch or circuit.
3
Inspect
Wiper Motor
Worn or faulty wiper motor.
Thank you
×