Dash board cluster lights not working on 2004 GMC Sierra. Are the bulbs fixed to cluster board?
SOURCE: Replace Dash light bulbs on 2004 Malibu Maxx
you need to take the hole dash out and on the back of the speed dash there are little bulbs take them out then replace them
SOURCE: How to replace light bulbs in the dash board of a
Get a Toyota shop manual before you attack the dash. There are a number of screws and clips that are not obvious, and there is a good chance you will get frustrated and break something if you just go at it.
On the Sienna, Your going to remove a good portion of the dash just to change light bulbs on the instrument cluster.
Get a shop manual, and the job will go smoothly. I would have not figured it out half the things is do without the instructions to what i am working on.
I know the dashboard HAS to come off. This may not help but I'm sure if you check the dealer they can give you an estimate of time/labor vs part cost.
Knowing the cost will make you invest in a shop manual, or you can go to Auto Zone or Parts Source for a print out, there free and you can get the parts from there too.
Good luck.
SOURCE: Need to replace burnt out dash board lights 2001 Toyota Corolla
Just remove the 4 screws and then slowly pull the cluster out and reach behind and disconnect the plugs on the back of the unit and then remove the cluster. The bulbs can be removed by turning them and pulling out.
SOURCE: No dashboard lights or tail lights but I got Blinkers and brakes
im having the same problem help please
SOURCE: on a 2004 gmc sierra, service air bag message on
There is no reset,you have to take it to a repair shop and get the codes read to see what is causing the light to come on.Usually just a sensor.When it is repaired the shop can use a scan tool to reset the light.This would be the the only way to reset the light.Hope this helps.Good luck.
559 views
Usually answered in minutes!
×