Are there any exploded views to replace the thermostat housing on the 2003 2.3L Duratec Ford Focus?
SOURCE: thermostat replacement 2003 ford focus se, with 2.0, 16 valve ztech engine
Follow the upper radiator hose to where it attaches to a housing (2bolts hold the housing in place) remove the hose clamp here and then remove the housing bolts, inside the housing is your thermostat. Clean off the surface of the housing, and where it attaches to the engine. Install the thermostat, and a new gasket (or O -ring ), carefully replace the housing, being sure the thermostat doesn't slip out of position, tighten the housing bolts, reattach the radiator hose to the housing, add coolant to proper level, check for leaks, u r good to go! Make sure the thermostat is installed in the right direction, if put in backwards the car will overheat. countrycurt0
SOURCE: how to locate thermostat on a 2000 taurus se 3.0l duratec dohc
on ataurs with a duratec the thermostat is on the bottom radhose underneath the car. you will see a little housing near the radiator underneath the vehicle. they are a bit of a pain to get at
SOURCE: Replace license plate bulbs on 2003 ford focus
if you buy some of those "on tv only" lights that are bubble shaped and plastic, you can duct tape those onto your license plate area and click them on or off when needed.
SOURCE: I need a Serpentine belt diagram for a 2000 Ford
It is not printed on a sticker on the cross bar in the front of the engine compartment where the hood latch is?
Thanks for your interest in FixYa.com
415 views
Usually answered in minutes!
×