How to reset
SOURCE: need wiring diagram for 2008 ford crown victoria
Hello,
You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.
Hope this helps,
Chris
SOURCE: I need the fuse diagram for a 2001 crown victoria
go to
http://www.motorcraftservice.com/pubs/content/~WO1CRO/~MUS~LEN/41/01croog4e.pdf
and check out pages 156 - 161. They provide all you have asked for!
SOURCE: '96 ford Crown Victoria....No hazard or brake light no turn sigal
Sounds like the multifunction switch. Try working the hazard switch up and down a few times to see if you get some lights to work. If so then replace the switch.
SOURCE: 2005 ford crown victoria shuts
Does it start right back up after it dies or do you have to wait. If you have to wait for a bit then it starts back up could be a fuel pump. It is very possible that if the fuel pump shuts off you lose pressure and the vehicle will just die, it won't sputter like many think. It's not like it is starving for fuel at that time, it just quits working. I know it is hard to diagnose but I have seen a Lincoln Town Car with similar issue and it was the fuel pump. That pump unfortunately is in the fuel tank. If this helps please give me thumbs up. Good luck.
76 views
Usually answered in minutes!
×