All of my Panel Gadges wont work? what could be the problem?

Could you be more specific on your problem ?

Check the fuses. Probably have a blown fuse.

Any codes? You may have a bad dash ground or need to change the complete dash.

SOUNDS LIKE A BAD GROUND, OR OTHER ELECTRICAL CONNECTION, DOES THE ENGINE QUIT.

Hi, I had the same problem. For my malibu (2000) it was a faulty ignition switch. I replaced it and the instrument panel works fine.

My guess would be the ignition switch itself since they are working in the axillary position. Never seen this happen personally, but has to be the problem. Don't know the model or year of car your working on, but if it's not a 60's model check your engine compartment fuse box or box's. Look for the ignition switch fuse's. On my GM car there are 2 60amp fuses that run the ignition on controls the starter circuit and the other controls the electrical system. Maybe not exactly how it works but would be worth popping the hood and taking a look at them.

If the car is still under warranty take it back to a Chrysler main dealer.

Otherwise it sounds like:

1) a loose connector in the back of the instrument panel

2) cable chafing against the bodywork (intermittently earthing the cabble)

3) an intermittent Alternator regulator fault

either you have a bad wiring prolem or you need new gadges

Usually the cause of more than one gauge failing is the small metal can regulator on the back of the gauge case in the dash

Its the cluster. Its about 500.00 dollars!