2007 Chevrolet Tahoe Logo
Posted on Apr 29, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Replacing the skid plate on 07 Tahoe Z71

Im trying to replace the "skid plate" on the lower part of the front bumper on a 2007 Chevy Tahoe Z71. I cannot figure out how to get to the top bolts. The bottom bolts are open but the top are covered by the bumper cover. How do I get to them? Thanks

  • Anonymous Mar 22, 2014

    Can't find radiator hose on 2004 Tahoe z71

×

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

  • Expert 85 Answers
  • Posted on Apr 29, 2009
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Apr 29, 2009
Answers
85
Questions
2
Helped
35063
Points
211

Remove bumper or use a swivel adapter to remove

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I need step by step on replacing washer fluid tank

Remove belly "skid plate air dam" cover to inspect
Remove front bumper assembly to expose the guts Thread Washer fluid leaking and headlamp washers powering but no water
4helpful
1answer

Location of oil filter

The 2007 Tundra 5.7l engine doesn't have a spin on filter - it uses a replaceable paper cartridge within a permanent housing. Located under the skid plate on the front-left portion of the engine, the oil filter unit has two coolant hoses, a black plastic screw-in housing, and a large, metal, round screw with a 1/2" square fitting in the middle of it. The cartridge-type oil filter is in the housing.

If equipped with a skid plate, access is accomplished by removing the 5 skid plate bolts, allowing the plate to swing down on integrated hangars (with the front plastic bumper skirt still attached). To completely remove the skid plate, three small screws holding it to the front plastic bumper skirt must also be removed.

Toyotafilter kits contain a new filter cartridge, a plastic drain plug, and two O-rings. The drain plug is used to drain residual oil from the filter unit prior to removing the plastic screw-in housing. After removing the large, metal, round screw with a 1/2" square fitting in the middle of it, the plug simply snaps into the bottom of the plastic housing. The smaller of the two new O-rings replaces the existing O-ring on the screw.

Once drained, the plastic screw-in filter housing is removed using a filter wrench (Toyota special service tool). The larger of the two new O-rings replaces the existing O-ring on the screw-in housing. VERY CLOSE ATTENTION must be paid in placing the new O-ring - failure to properly seat the new O-ring could result in a massive oil leak! The filter itself is currently only available from Toyota.
0helpful
1answer
0helpful
2answers

Cant find oil filter on 1991 chevy s10 blazer

i had a 96 so it may be different... there was a "remote" oil filter under the plastic skid plate just behind the front bumper... it took a flat screwdriver to open an access panel.... just a quarter turn of he screw and the door would open... hope this helps.... let me know... i can keep looking if it doesnt
5helpful
1answer

I have 2000 Chevy Tahoe Z71. The security light stays on

1999 chevy tahoe security light goes on while im driving does
not seem to cause any problem
0helpful
1answer

Replacing the oil on a '07 Nissan Pathfinder

no the drain plug is right there and there is a 10 millimeter bolt holding a trap door for the filter so no you dont
0helpful
1answer

Identify a part on the front bumper, 07 Pontiac Grand Prix

the is the radiator air dam it is also known as the front spoiler.
1helpful
1answer

Replace the face skid in the front bumper

remove front bumper and it should be clear what holding the face skid in place
Not finding what you are looking for?

582 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...