SOURCE: 1997 GMC Sierra Ignition Switch Replacement
take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and give it a good tug. then once you have the new switch and you get in there your going to need an inverted torx socket to remove the small bolts that hold the switch to the column. do not move the gear on the new switch make sure it lines up exactly as the old one did!!!!!!!!!!!!
SOURCE: Brake lights quit working.
if all fuses and bulbs are ok get to the brake switch and see ifits stiff or stuck, if it just has two wires on it you could join themtogether to see if the brake lights come on though obviuosly dont leave them joined.Good luck davelee
SOURCE: 1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
204 views
Usually answered in minutes!
×