2003 Dodge Dakota 4.7l 300kilos . Throwing different codes on OBDII. Cam Sensors-replaced, crank sensor -replaced, iac-replaced, pcm-replaced, throttle body cleaned. Now getting skim-key faults. Truck will start and run, then intermittedly dies. Any help?

SOURCE: 1997 dodge dakota v6 engine wont start replaced

turn the key to the on position a see if you can here a buzzing sound around the fuel tank,if you don't hear a sound then. (be very careful while doing this) with the key off take a fuel line coming from the tank loose,make sure its pointed away from you and turn the key to the on position,see if any gas comes out,if not then your fuel pump is probably bad.

SOURCE: 1996 Dodge Ram runs and dies

Google for Refurbished PCM "brain" and call the site from Florida. My Durango kept stalling wihtout warning and I replaced the PCM for < $300.00 and no problems since.

SOURCE: 2000 dodge intrepid 2.7 sputtering, revs up

you need to ck some basics you could have a vacuum leak which would hide during warm up but cause havoc when hot,the leak would cause high idle then your pcm would try to lower idle to spec thru use of idle control motor causing surging idle ,also fuel pressure needs to be checked while acting up,may be more cost effective to pay for an hour of diagnostic.

SOURCE: 2003 stratus cam sensor replaced still unresolved

you bypassed the wires that connect to the sensors? that would have been my first guess the harness that plugs into the sensor. after that i would check the ground connection from the ecm. wouldn't hurt to check the battery posts too. if the battery posts are oxidized you can have all kinds of goofy electrical problems. hope that helps.

SOURCE: 2003 stratus both sensors replaced still unresolved

Have the exact problem. Replaced cam sensor and timing belt. Still happens intermittently. code is p0344.