Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Oct 25, 2013

I HAVE A 97 DODGE B2500 CONVERSION VAN WIPERS JUST STOP WORKING PUT NEW MOTOR AND RELAY STILL NOTHING HAS POWER TRIED GROUNDING IT STIIL NOTTA WHAT AM I MISSING

5 Related Answers

Anonymous

  • 1201 Answers
  • Posted on Jan 27, 2009

SOURCE: 1990 Dodge Ram Wiper not working

You did everything else. You have voltage going to motor,so I would say that was it.

Ad

Anonymous

  • 1 Answer
  • Posted on Feb 11, 2009

SOURCE: 97 dodge intrepid wipers not working

My Chevy was having troubles with the wipers and had to put a large zip tie around the motor and wiring connection. The post were worn down just enough for it to lose contact. The Zip Tie holds tension on it.

Anonymous

  • 75 Answers
  • Posted on Feb 15, 2009

SOURCE: blower motor does not work at any speed

as you said relay is good,try to check 4 connection of relay,pullout relay,check if there a 12 volts supply,, a 12 volt control by ignition sw.,connection to blower motor, the last connection is to the switch mostly connected to ground.

Anonymous

  • 580 Answers
  • Posted on Jul 08, 2009

SOURCE: 4x4 conversion of 1995 b2500 Dodge van. I want to

There is 4X4 convrsion company called Quigley thy have done 4X4 conversions for ambulances and off road campers try www.quigley.com for assistance. They may have what you need.

Anonymous

  • 1071 Answers
  • Posted on Jul 21, 2009

SOURCE: 1995 dodge dakota. Wipers switch only clicks

there are grounds that join behind batter remove battery check for corossion clean up and rejoin splice should work again

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 1998 dodge ram van, the windshield wipers stopped working, the fuse is ok and the washers work ok. all other functions of the switch work properly. How can you test the wiper motor and wiper

Make up a set of jumper wires that will accommodate the wiper connectors and run an auxiliary ground wire to be sure it is not a ground problem and then jump power directly the power lead connectors on the motor.
0helpful
1answer

Wipers wont park 1997 dodge ram replaced wiper motor now wipers stop up high speed also dont work

be checking for proper ground to the wiper motor and fuses or relay controls..
0helpful
1answer

1998 dodge van, wipers out of sync, got them back working without hitting but the wipers go past bottom stop then come back up a little before stopping

remove the wiper arms from the pivots
cycle the wipers through their travel to a park
install wiper arms back on in the parked position
2helpful
1answer

1990 grand caravan wiper and radio works intermittently. Wiper will start if you give it a push on the wiper blade, but doesn't keep working. Radio comes on when it feels like it. When you turn the key, it...

Try cleaning the wiper motor ground wire at it's grounding point or where it connects to the frame. Also when a van or car sits for a while, things begin to rust. Try cleaning your ground from motor to frame & clean your battery terminals. There is a possibility that you have a flat spot on the wiper motor but I doubt it. Try these things I've suggested & I hope this solves your problem. Good luck!
0helpful
2answers

1986 Dodge Ramcharger - new wiper motor, fuse, switch and relay. Getting power, but still won't work!!

the ground for the wiper motor is not working run a wire from the negative on the battery to one of the mounting bolts for the motor then turn on if works OK make wire permenant
2helpful
1answer

1995 dodge dakota. Wipers switch only clicks

there are grounds that join behind batter remove battery check for corossion clean up and rejoin splice should work again
0helpful
1answer

97 dodge intrepid wipers not working

My Chevy was having troubles with the wipers and had to put a large zip tie around the motor and wiring connection. The post were worn down just enough for it to lose contact. The Zip Tie holds tension on it.
0helpful
1answer

97 mazda truck wipers wont work

the motor ground is controlled by a solid state control module called the GEM (Generic lectronic Module), it is most likey burned out by the voltage surge of the strike, it is behind the radio, about 2" square and black plastic case
Not finding what you are looking for?

174 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...