SOURCE: P0441 EVAP Control System Incorrect Purge Flow
Test the purge valve and the vent valve for leaks. This can only be done with a Tech 2 and or a vacuum pump.
SOURCE: what will be the cost of part and labor for po440
If you have P-0440-P0441-P0446, you can usually trace that condition to a loose fuel cap, or a fule cap that has a bad rubber o-ring, or rust build-up where the cap's o-ring seals against, at the filler neck opening. The cap is about 15 dollars, and the replacement filler neck is about one hundred sixty dollars
SOURCE: engine light on Codes show
Hello! Those three codes commonly indicate the followi possibilities:
The gas cap was not sufficiently tightenend ater fueling, a bad gas-cap rubber o-ring, the vehicle had the key in the 'on', or engine running, or the tank was filed all of the way up the neck.
Any one of the abope causes will set all three codes.
SOURCE: evap purge system failure code po441
Check the gas cap could be lose or not sealing properly..
SOURCE: My name Tommy V, I have a 2001 Toyota Echo, the CK
The EVAP cannister is part of the emissions system. Excess exhaust runs thru it-purge flow is when it is released. Check all the vacuum lines going to it. I don't you will find a parts listing for a purge flow valve or vent or solenoid. Your light will probably come on again shortly.
A code P0441 could mean one or more of the following has happened:
Possible solutions:
With a P0441 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:
44 views
Usually answered in minutes!
×