1985 33 ft fleetwood southwind 454 i need the ignition switch asm color cold for the plug to put the wires back on the right pins of the plug

Ignition switch, starter relay, starter, wiring, locked up engine. Could be a number of things.

You need the details of the engine and chassis that they RV is built on. Normally something like a Ford F-350. Once you know that, you can search for parts and diagrams. Looks like a Chevy 454 P chassis. Then it depends on what hoses? A properly crafted search query can find most things.

https://www.google.com/search?q=Chevy+454+P+hoses

https://www.google.com/search?q=454+1986+Southwind+RV

https://www.google.com/search?q=wiring+diagram+for+the+motor+on+a+454+1986+Southwind+RV

..

www.fixya.com/cars/t19787327-fleetwood_southwind_fuse_box_diagram

What is the question?

You probably have an electric one with a filter at the fuel tank plus a standard mechanical one mounted on the engine, or possibly an electric one mounted in the fuel tank.

hi bruce.
try this link out might help you find out why.
1991 fleetwood southwind motorhome wont start no power to solenoid Google...

Connector Part Information • 15416722 BLK
• ASM Conn 12 F GT
Pin Wire Color Circuit No. Function
1 DK GRN 1433 Clutch Start Switch Signal
2-3 -- -- Not Used
4 YEL 772 Transmission Range Switch Signal B
5 BLK/WHT 771 Transmission Range Switch Signal A
6 GRY 773 Transmission Range Switch Signal C
7 BLK/WHT 451 Ground
8 WHT 776 Transmission Range Switch Signal P
9 LT GRN 275 Park Neutral Position Switch Signal
10 GRY 1524 Back-Up Lamp Supply Voltage
11 PNK 839 Ignition 1 Voltage
12 PPL 639 Ignition 1 Voltage
This all I could find, hope it is the correct one.

where can i find the fuel pump on a 1988 fleetwood southwind

Hello,
Does this leak have a color to it? Take and dip your finger in it and put it on a clean white piece of paper. What color do you see?
Regards, Tony

I can't give you a schematic but i can tell you where the wires should go;Battery post of the alternator should go to the center post of the battery splitter box that splits between the engine and the house.In the alternator plug the wire closest to the battery post of the alternator needs to go to the charge light or an ignition source.The other pin in the plug can just be looped the the battery post of the alternator.If you have no power to the alternator but do have power to the box that splits the power from vehicle to house the you need to put all the wires on the post marked batt until you can get a new one,this should get you up and running.If you are planing to remain camping with the temporary repairs made then separate the wires until you are ready to start the camper to prevent a dead battery condition if the house battery gets run down.Hope this helps.