Nissan sentra keyless

Paul W

• 404 Answers
• Posted on Feb 05, 2009

SOURCE: Nissan Sylphy Intelligent-Car Remote Controller Not Working

Hi,
Some key fobs are coded and if this is so you will need to take it to your Nissan dealer with all details of the vehicle i.e. Log book/title and vin number proof of ownership. There may be a small charge for this.
Good Luck!
Press the Blue Button please when satisfied with my FREE effort, Thank You!
Paul 'W' U.K.

SOURCE: power steering reservoir for 2008 Nissan Sentra 2.0 S

I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.

SOURCE: 2002 nissan sentra gxe computer

buy a used unit from the junk yard.

SOURCE: brake light, 2008 Nissan Sentra

Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

Ahmed Raza

• 41 Answers
• Posted on Jun 22, 2009

SOURCE: How do I change brake light bulb of Nissan Sentra 2008

Was able to complete this job successfully:
It's a little tricky to do without pictures, but I don't have any available right now.

1. Access the trunk
2. Remove the material covering the light. You'll need to remove the black pegs by lifting the centre part. A flathead screw-driver will help. There are 2 to remove -- one directly behind the brake light and another at the top of the trunk.
   
3. Pull back the material to expose the brake light wiring and the metal frame of the car.
4. There are 2 nuts / screws to remove near the entrance of the trunk. Both are about 4 inches apart and hold the tail light's cover in place. Remove both.
5. Using a bit of force, you will be able to pull off the entire tail light from the frame of the car. This is done on the exterior of the car.
6. Rotate the problematic light from it's housing (it should come off with ease) and pull it out of the socket. Brake light and indicator are a 3057K bulb.