Hi i have peugeot 407 2005 the car started giving me break system faulty 1 month ago so i went to a repair shop and paid around 300 usd to change all the break pads all new back and front ,now the car is giving me 2 massages one is break pad worn and the other one is break system faulty its so annoying and it keep gives me stop sign what to do pleaes help me
Hello,
Take the vehicle to Autozone, Oreilly's, NAPA, they will put a "CODE READER" on your vehicle for FREE to help diagnose the problem. They will also show you where the part is on the vehicle and loan tools but they cannot replace the part for you.
Sounds like a sensor either on the pad or on the mastercylinder.
I hope this helps.
SOURCE: need to change rear pads and adjust hand brake on a 407
right the hnad brake is located on the center console at the right of you in america or left if you are are from brittan. pull it=]
SOURCE: Replacement brake pads for 06 Lexus GS 300?
go with standard pads.they wear a little faster than ceramics.but they dont wear down brake rotors.ceramics pads are hard and they cause brakes to squeak.also your car is under warranty with lexus dealership.i would use what they said. because you have future brake problem. they will void out warranty for not using their brakes.
SOURCE: 407
it is a warning of something fault in your car it is probably with electricity and you cannot know it you must go to a peugeot service center to fix it
SOURCE: Peugeot expert van with stuck on brakes
It's the rod that runs from your brake peddle to the marster cylider the links seized up. need To take off and free it up
SOURCE: Peugeot 407 SW 2006 wash wipe, no water coming from front.
The pipe that caries the water come off the connector under the wheel arch, you have to take the wheel off on the side of the water reservoir and the protective lining. Apply a bit of super glue to it, it's not very difficult to do.
207 views
Usually answered in minutes!
×