SOURCE: Front Hub Bearing Torque specs to complete replacement
THE LUG NUT TORQUE SPEC - 140FT/LBS\
CALIPER MOUNT - 80FT/LBS
CALIPER BRACKET 129FT/LBS
AXLE NUT 177FT/LBS
SOURCE: I need the torque spec for the axle and the axle
Go to the autozone.com website and register there. It doesn't cost anything and you will have access to an online repair manual for the vehicle. (Kinda handy) They have a specification section, so the torque specs might be found there. Hope this helps and best wishes.
Testimonial: "hey thanks for the help"
SOURCE: 2007 gmc sierra 2500 IAT sensor
Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.
SOURCE: brake job torque spec
Caliper mounting bracket bolts:
Front: 80 ft-lbs.
Rear: 41
Caliper mounting guide pins/bolts:
Front:
Four-cylinder models 26
V6 models 37
Rear:
All: 17
Hope this helps you.
1,686 views
Usually answered in minutes!
×