I have a mitsubish RVR 2001 model, I want to know where all the engene sensors are located. My car stops/ cuts engine from running even when I am travelling but when I stop for some time, say an hour, if I start the engine, it will start running again bt stops itself after running a few killometres. if I try to start the engin as soon as it stops or a few minutes after it stops, it will not start.

Marvin

• 85242 Answers
• Posted on Nov 19, 2008

SOURCE: 98 galant motor stalls - dies when gas is pressed

I would take a look at possiable damage to the PCM (powertrain control module)

alex metro

• 364 Answers
• Posted on Nov 25, 2008

SOURCE: 98 eclipse Engine stall but stars

Sounds like your IAC (idle air control) motor needs to be replaced. If you are driving on the Interstate/freeway/highway for a bit and then get off, the car dies when your coming to a stop right?

SOURCE: 2001 mitsubishi service engine light

this light will come on if you have a problem with the emissions system. Take it to a place like autozone and have them scan it for codes. list the codes here and we can help you out.

SOURCE: Mitsubishi Carisma 1997

its a very common fault with the GDi engine, normally first shows a fault after 60k miles. Fault will also make the engine feel slightly juddery on occasions whilst cruising... either/both Accelerator body or Cam sensor are the usual culprit. Both can be rather expensive.

SOURCE: gdi 3500 pajero not giving me enough power and throttle

I have mitsubishi Pajero GDI V6 3500, i was on the high way and suddenly the movement became very slugsih. i contacted my Auto mechanic who discovered that one side of the engine is not performing, the left side exhaust was cold while the right side was hot. ie the cold side injection nuzzles does not work , please what could be the possible solution ?