Mercedes benz E200 2006 (E211). My mercedes benz start lossing power after some time i driving. When I start a car it runs completely normal and after some time it just lose power and kick down wont start. When I stop and restart car it work normal again.
SOURCE: Ignition failing to start -S280 MERCEDES BENZ 1999 MODEL
Crank shaft position sensor is bad. This is the most common failure. Its location is on the rear drivers side of engine, where the transmission bell housing mates to the engine, only one small bolt and a two prong electrical connector hold it on. Usually will not throw a trouble code. If you remove it you can test it with an ohm meter, will have an erratic reading or read open loop, can malfunction intermittently or permanently after parking vehicle and won't restart. Applying some heat source to it during ohm testing with a hot air heat gun will usually cause the sensor to read open loop if your not sure if its bad or not. This reply is probably way to late, but I just happened to come accross it while online. Harry (master certified MBZ diagnostic tech)
SOURCE: 1999 Mercedes Benz ML 430 periodically stalls at idle
Hi, Joe here The problem sounds like a faulty crankshaft position sensor. The sensor is located on the transmission bell housing on the left side. Can be accessed threw the top of the engine near the firewall.
SOURCE: switch to 4 wheel drive in Mercedes Benz GL450
You have permanent all wheel drive dude. The system is always ready to go. If you want to do some offroading, activate the "off road" button that looks like a vehicle climbing uphill on the lower, center dash panel. This will allow more slip for the traction control system and hold lower gears longer in the trans
SOURCE: My mercedes Benz C 220 stalls when I come to a stop or in park .
Is the AC on? The compressor can take alot of power and make it lope. Engine mounts can make it shake. coils, cap, rotor and wires for tune up at a minimum. EZL if you can find one cheap. MAF also can cause issue. If it is a 1991-1995 check the engine wiring harness as they get brittle and degrade.
360 views
Usually answered in minutes!
×